when I'm crusing at low rpms third gear slips or the engine misses or something just when I shift te slower i'm going the worse it is. most of the time I shift...
Tommy, a transmission wouldn't slip. It might jump out of gear, but I can't imagine a circumstance when it was actually slip. My first thought is that the...
it's bad at anything under 5000 RPM. and it says 9900MI but it was wrecked so it might not be the original odom? the dealers mechanic says it sounds like the...
Well, I'm not the most technical guy around. I was thinking bad chain and sprockets or maybe it's just not turning fast enough. But mine pulls cleanly from...
Hey Gang; I was wondering if anybody has changed their Zrex turn signals over to High Intesity Led lamps like the ones at SuperBrightLeds.com? It will...
hey guys in case the first message didn't post i am looking to see if any one in the US has a set of stock headers for zrx 1100 and also can any one tell me if...
Welcome aboard. I'm about 99.5% sure the entire exhaust from a 1200 will bolt onto an 1100. That should cover me if you were to buy one and it didn't ;) I...
I have a set of headers with stock muffler from an 01 1200 supafla777 <supafla777@...> wrote: hey guys in case the first message didn't post i am looking...
thanxs for the prompt response i am interested in the headers only from the 99 1100 as i allready have the slip on give me a good price including shipping to...
well since stew didnt respond i have a scorpion slip on can for the zrx 1100 do you think your zrx 1200 headers will have the same bolting pattern for the slip...
... I've got just what you're looking for. I recently replaced the stock exhaust on my '99 with a full aftermarket setup. If you're interested, I could look...
hi ,thanks for letting me in to your zrx site, i am a 63 year old and have two kawasaki,s 2000 zrx and a 1884 Z1100R ELR, AND A DUCATI 996, check out my pic...
OK. You have to go now. It's not that you're unwelcome. It's just that, at 60, I've grown rather acustomed to being the oldest one here, and I hate to give...
Welcome from one hencnec to another. I am 63 also and have an '03 ZRX, '85 CB650SC. 72 CL450, 73 CB450. Wish I had a CB1300 but Big Red does not sell them...
Dear fellow Hencnecs, You guys are making me feel like a virtual kid at 57. I have a '02 ZRX1200R. My wife is always making a big deal about me riding that ...
Well, I guess I only *thought* I'd been the oldest one here before hencnec ;o) I rarely join them, but a few weeks ago I went along on a sportbike ride with a...
I have an 848 that I have been using on the track and recently rolled the REX out after it had sat for a couple months and went for a lil spin. I had forgotten...
Hi, I know ya'll heard this before, but I've yet had to do this. I have a 99 zrx1100, nice green one. I need to change the sprokets, the rear has broken teeth,...
Stock is 17/45. I went to a 47 on the rear with the stock 17 on front and liked it OK, but I've since gone back to stock gearing. I just don't use 5th gear...
... stretched >out about as far as it's going to go. Any suggestions whether I should keep them >stock or change the number of teeth. Also manufacturer and...
I went the other way from a 17/47 to 18/47 combination. I feel the 'rex has enough grunt so I put an 18 tooth to lower the r's at highway speed. I also got...
I went the other way from a 17/45 to 18/45 combination. I feel the 'rex has enough grunt so I put an 18 tooth to lower the r's at highway speed. I also got...
The problem is when I'm at a high speed (50 60 ) and I'm making a turn, I get a little wobble. Its not a smooth turn.fighting it a bit. The bike is a 1999 ZRX...
There are too many variables to diagnose a suspension problem based on one symptom. This could be a mechanical problem or simply suspension not set up...
... I had the bike for a year now. I weigh 165. Its been this way since I got it. I know I need tires. Have a mis-match set on it and the front tire is culp....