Hi there you guys, I'm writing you `cause I want to congratulate you for this very useful message board that you have. On the other hand I'd like to use your...
Hi Pablo, This is a nice project and you have done some good work on the bottom end. What year is the motor? I think it is similar to the two liter Zetec...
Has anyone had any experience with Kent Cams in the 2 liter Zetec? I spoke with FocusSport today, which carry Kent Cams, and they said that they don't have...
you can use the intake cam - the focus and zx2/contour vct motors will allow an interchange... the exhaust cam as you pointed out is not the case Rob ... ...
Esslinger is testign a new ZX2 exhaust cam now. Its designed for more higher RPM use and may work with your motor. Tits the same lift as their .405" list...
there's also higher lift cams being developed w/ taller kash caps for clearance. the higher lift Kents need a little clearance grinding around the buckets ...
I would like to know how expensive it would be for one powdercoated in Ford Blue. Geoff C. ... __________________________________________________ Do You...
Thanks Guys, The info on the cams is what I had expected, thank again! I am currently trying to get information on availability of Kent Cams, specifically on...
Hi all, Can anyone confirm if the flywheel and starter from a Focus Zetec are the same as the Contour Zetec? I'm having a hard time finding the bits to...
If any of you out there need them, I have made available a steel flange that matches the catalytic convertor flange on the ZX2 (2 bolt) and Focus/Escape (3...
If any of you out there need them, I have made available a steel flange that matches the catalytic convertor flange on the ZX2 (2 bolt) and Focus/Escape (3...
Hi Jim M., I have a '98 Contour Zetec and I have fitted an after market Escort ZX-2 flywheel. The Escort wheel is a little smaller in the clutch contact area...
Hi all, I just found your group and think its great! I am located in Alberta, Canada and own a Birkin Super 7 which runs a Ford Zetec 2.0 140hp. I was...
(1998 Ford Escort ZX2 2.0 DOHC..)(Birkin S-3) Now that you mention it Pete, we have a new mystery and another apparently Weber related problem. From what I am...
My 914 had the same problem. The mixture was set way too lean and as soon as I gave it any throttle it died. However it was a slightly different weber model...
Thanks so much Chris, We are really at a brick wall with this thing. Seems as soon as we get one thing right something else crapps out. Funny thing is we...
Hi Folis, A couple of general questions first, since I'm not specifically familiar with the Birkin Weber configuration. What size are your DCOEs, 40 or 45mm? ...
On Sunday, August 18, 2002, at 09:44 , "Folis Jones" ... I'm no weber expert (not even a novice! I run throttle bodies...), but I have a few friends who run...
Thanks Stan... They are 45DCOE's and brand new out of the box. If you open the throttle slowly it spits and runs ragged, if you blip it the response is good....
Hi Jim, Thanks for the input. The carbs are new with stock jetting, as the engine is box stock too. This is not a tuning problem, i.e., correct jets or not,...
Folis I would suggest you go back to original settings on the carbs. Whatever they are supposed to be. I am assuming you have a Weber rebuild/settings book....
Thanks Briggs, We have done all you suggested. The EMS system does not allow for timing checks, it is pre-programed. We have new ignition wires, new plugs,...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
