Hello every one, i have 1989 subaru xt-6 that i'm parting out,its red,automatic,non turbo with around 106k miles, the car runs and drives good. the engine and...
can you tell me what kind of suspension does it have? rick _____________________________________________________________ Click to make millions by owning your...
Hi, Is it AWD? I need the rear hubs and backing plates. ~Phil ... _________________________________________________________________ Windows Live Hotmail and...
i have one but it needs suspension work new jersey _____________________________________________________________ Click for free info on online masters degrees...
Hi, I am looking for the left front lower control arm and hub for an 88 XT6. I am wondering if you have those parts and if you know if they would work with an...
steve, yes any stock XT6 parts will interchange - including all the suspension...hub, control arm, etc. if you're not a member be sure to check out the XT6...
Hi, Looking for rear hubs and backing plates if it is an AWD. Thanks! ~Phil _________________________________________________________________ i’m is proud to...
Hi All, I'm still in need of the rear,lower left cornor of the trunk floor/quarter panel for a '91 XT6. I don't need a huge piece, just enough to repair a...
My daughter crashed my 6 and I am in the middle of repairs. I have found an XT turbo hood and want to know if it will fit my XT6. Any experience out there? ...
Only difference is the hood scoop Garry _____ From: xt6@yahoogroups.com [mailto:xt6@yahoogroups.com] On Behalf Of carstensenjohn Sent: January 11, 2008 8:17 AM...
Depends on the year of the turbo hood. 87.5 and newer are no problem. Before 87.5 and the latch will not line up. Radiator core support is straight across...
Hi All, I had a devil of a time getting a refill blade to fit the wiper on my '91. I called Subaru and the parts guy finally found the listing and asked if I...
Bosch makes one and it comes with the addapter (its like a 21-22 in blade) I picked it up at checker auto parts it was like 15-20 bucks tho Shawn ... ...
We suspect that the timing chain broke in our 89 xt6 while driving it on the freeway. it has 186k miles. Does anyone know if in these cars the valves in the...
The XT6 has what is called a non-interfering engine, meaning that the valves can not contact the cylinder heads. So, there won't be any damage due to the...
There's no possibility of internal engine damage with a broken belt on an XT6. non-interference like Mike said - the valves can't hit the pistons and valves...
The xt6 is a noninterferrence engine, so no damage was done. Its most likely you are talking about the left timing belt, which carries the heavier load, that ...
thanks for all the replies. i priced them and since they are not that expensive, while the mechanic is in there should i have her replace both sides? also i...
Angela - depends how long you want to keep the car. if you want to keep it awhile that kit is not a bad idea. The timing belt pulleys are all old and low on...
how do you reset the computer throwing the code for the knock sensor (#22). I pressured washed my engine, and the check engine light came on. The computer is...
knock sensor is different on the XT6. it's located in roughly the same area as the EJ stuff, under the intake manifold and towards the back of the engine and...
if your model is the same as mine, disconnect the main wire harness from the box, then disconnect your battery and the pull your main bus fuses. when you put ...
- If you know where I can get one with: - AWD - automatic trans - no major leaks - that great scissors jack under driver seat . . . please write me at...
