I *think* the key needs to be in the "ON" position for an hour. Or, the procedure could be different for the Bose system. Is there another separate manual? ...
I had/have a problem with mine where the fuse hoder in the back of the radio does not contact properly because the pins holding the fuse have spread. This is a...
I think if you screw up the code "3" times in a row, the radio will display "1000" and require you to sit for an hour before trying again. Try to leave the...
... In my US spec 1995 GTI VR6, the display shows SAFE and you're supposed to press MODE and SCAN simultaneously and hold until "1000" appear. The "1000" won't...
Hi everyone. I have 2000 Jetta VR6 with 46k miles on it which suddenly stalled turning a corner with the cluth in. When it happened the CE, EPC, and the...
I had to take my steering wheel off after VW replaced the ignition switch as the contacts were noisy, everything went well and the noise went away with a just...
The only way I have found to get rid of it is to use a scan tool (Vag-COM, or a VAG1551). The solution in the furture, is when reconnecting the batters (you...
Hi everyone. I just pulled 4 fault codes from my Jetta and wanted to know if these are stored/displayed in any order. Codes were: 17832/P1424, 17536/P1128,...
Hi guys, as you may know I've been trying to solve my engine problems by checking all my vacuum hoses for leaks. Well I did, I replaced all vacuum hoses but ...
I took my vehicle into my local VW shop for service. When I entered the vehicle afterward, the power outside mirrors were mis-aligned. I aligned them, then...
My MAF sensor is broken! I have VAG-COM software and interaface, and checked my car MAF sensor, fault. On close inspection there is a crack on the thin flim. ...
Since you live in the UK, I'm not sure how much help this is. A few sites sell the Mk3 OBD2 VR6 MAF sensor for a little bit cheaper than 300GBP (I don't know...
How the h___ does the bottom half of the air box come out. I've looked in ETKA and they don't show anything (that I can see) that *fastens* it in, but there's...
If anyone is in need of a donor car, or a parts car, I have one I am looking to get rid of. I am located in Central PA. It's a 93 VR6, Automatic, needs a head ...
Jared Wolgemuth
Gipper_VR6@...
Aug 19, 2003 6:32 pm
2870
Thanks Nathan, Water pump is changed. Couldn't a done it without you. Jim...
I just replaced the coil (second Beru in about 15,000 miles) and now I have a steady drip drip drip oil leak coming from above and behind the coil - I think...
Hi Steve, I hate to say this, but you should steer clear from Beru coilpacks for your VR6. They are generally priced very cheap online, but most folks are...
Wondering what is wrong, if any of you had this similar problem. My a/c does not blow cold at idle/low speed. When I reach roughly 40 mph or so, the a/c is...
... And when you slow back down, does the A/C get warm again? ... Or it can be that you have a leak. Since I am currently trying to figure out why my A/C...
I just had the air in my 93 Passat repaired for $250 instead of $1700. One place claimed I needed a new evaporator. At a radiator shop in Oakville Ont they...
I just had the air in my 93 Passat repaired for $250 instead of $1700. One place claimed I needed a new evaporator. At a radiator shop in Oakville Ont they...
Really? I'm interested to know which components comprise the high pressure side and which comprise the low pressure side, and where the line is. Jim '93 SLC...
I am not diagramatically familiar with the system but what I was told ws that there are two sides to the lines form the compressor. The high pressure side and...
So you were reffering to the pressure line and return line on the compressor. Theres still a good deal of pressure in the return side, but they are named that...
96.5 model definitely has R134 system..that is what my 96 Jetta has. If an older model was converted, yes, it is a closed loop, but there is valving that...
