Hi, Did you ever get to the bottom of the rear hub oil seal thing? I have got a 1975 Primavera. Bought a 37x27x7 oil seal and it doesn`t fit either !! I was...
... Thanks for everyone's help (even if I managed to confuse you all).I have split the casings tonight and the bearing is shot..just got to wait for the...
That seal is right when you press it in will compress some.be sure to pack it full of grease as full as you can get it, Other wise is just a waste of a seal...
Looking for advice on tuning a 1985 PK50 xl. I've owned a few smallframes but always kept them stock. My real dilemma is to either tune the stock PK50 motor or...
You are going to have to methodically go through the basics until you find out what is wrong. It could be a bum fuel tap, a piston installed backwards or...
Thanks for verifying that. The exhaust I got to replace the old one didn't quite fit perfectly so there may be a leak there. Do you think there is an air leak...
It is very hard to diagnose problems over the "phone". You have to approach it in a methodical way eliminating one problem area at a time. If you think you...
Hello all, Joined recently and thought I would say hello. I also joined in the hope of getting help so be as well starting right now. After 20 years of storage...
from what i understood the 90 Racer was an SS90 engine in a slightly longer more primavera-like frame? could be totally wrong tho, as we only got SS50s and...
I've never seen the racer either. We didn't get them in the US to the best of my knowledge. The VIN/Engine numbers all start with: V9SS2T. Max On Wed, Jun 3,...
Hi there Jack - welcome to the Smallframe Group. As far as I am aware the 90 Racer was produced in very small numbers between 1971 & 1974. It looked very...
Hi there once again Jack - I just checked on the engine specification page of "Scooter Help" - the SS Racer Engine V9SS2 was exactly the same as the SS90...
I have a two coil stator from a mid-1960's Vespa 50cc. It uses an external ignition coil mounted on the engine case. The problem is this: The stator has...
It's the same engine and spec as in the ss90. There were using up spare engines from the slow selling ss90. http://ss90.com/ (has a photo or two) John...
Thanks to all that have offered help so far. Dave - I have sent you an email. It is correct that the frame appears to be basically the same as a Primavera...
More 90 racer photos: http://www.dierollerfabrik.de/index.php?id=8 (scroll down) There is also a section on the "racer 90" in the 4th volume of the Vespa...
Thanks John, I checked the frame tonight and it does indeed have the holes located for an angled script style badge. The more I think about it the more I think...
Hello everyone, new here. Quasi-inherited a '74 90 in need of tons of TLC. The first order is the broken headset..so I can at least drag it around and go the...
No you can't weld it as it is too hard to get at. They usually crack/ break when the scoot gets crashed so make sure it is straight before going too far along....
You can weld juat about anything on that head set , are you talking about the lock area got cracked? I make new front forks for Pseries and primavera's The...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
