Selling the top end from my Primavera. Was running fine when I took it apart for a performance rebuild. Also selling the Dellorto 19/19 carb and manifold. ...
Hi I am straightening my small frame and I need a measurement form the top of the fork tube to the front tip of the frame right below the front of the seat. ...
Please help me troubleshoot. Scoot has a polini 130 topend, new 19/19 carb, and 76 main. Just getting this assembled w/ new seals and running for the first...
hey guys, This isn't a small frame question, but was wondering if someone might be of assistance. Durso suggested I give this yahoo group a try. I have a '76...
Hi there, just a quickie Will 24mm brake pads fit on my V50n. I got sent the wrong ones, instead of 20mm. They say the 24mm are for the v50 special but was...
yeah, that's not anything i would worry about. just make sure that the edge won't impede fitting the seal. i would use some locktight to hold the seal in place...
We are seeking bikers to ride with, and take to biker rally. Now, lots of bikers joined. Many biker girls, boys, women and men gather here. If you want to join...
So then, I ordered some 24mm brake pads from SIP which in the title were specced for V50 Special, at the bottom where it says "this product will also fit the...
Hey kids. We decided to re-make a famous old German Nudie/Vespa Calendar. We had to make a 1,000 of them to get it done. We've sold 500 of them in the last...
could be that you snagged the clutch-side seal when reassembling...smoke, oily plug and no idle are all usual symptoms of that. if you have a stethoscope then...
i will try new gas and be sure to get the oil mix right at 2% although I doubt that's the issue. If the seal is bad, will i be able to smell gas in the case...
sorry. one more relevant item. i did have the scoot running a couple months ago and was able to set the idle to a reasonable tickover. I did have a good...
if the seal wasn't seated properly and spinning inside the casing if the seal lip was folded over or caught when putting the crank back in (need to lube up the...
one last question then i will start running down the list of suggestions. when you say 'bad fuel valve', do you mean the fuel tap? I have noticed that the tap...
Thanks jon! with a torch I was able to heat the collar enough to tap it back in place with minimal cracking. I put a layer of jb weld on both sides to give it...
We are seeking bikers to ride with, and take to biker rally. Now, lots of bikers joined. Many biker girls, boys, women and men gather here. If you want to join...
Hi All Hope someone can help! I'm rebuilding a PK80 motor at the moment with a ported 100 top end. I've replaced all of the main bearings (including clutch)...
I'm rebuilding a pile-o-parts v9a. Parts diagram suggests there is some kind of oil seal (part #150579) along with the roller bearings in the front fork...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
