hey guys, looking to see if anyone might have some jets they would want to sell......I need a main jet for a 25mm dellorto.... something between 107-110.... ...
I have all jets.... $5 each. What in the world is that 25mm on that needs jets that large? I hope it's a lambretta. -Max Motorsport Scooters 619-280-1718...
Hi all, I'm looking to buy a replacement for my PK 75 chassis with any other straight and rustfree smallframe chassis, any offers considered with price...
ported malossi 136, VSP pipe, case reedvalve.......I'm at sea level...according to the malossi book it recommends a 107...I have a 104 in there now and it's...
On a similar setup I ran a 90 main, and think most others have too. My barrel wasn't ported. I trust you, and I have the jets either way. The malossi catalogs...
Yeah you can get new locks. A locksmith / key cutting place may be able to sort you out with a key to fit the lock, but I get the impression vespa locks are of...
Hi all! Curious to see the islands of the Philippines? Click here <http://pinascoot.blogspot.com/2006/02/video-sa-roma-at-scoot-ni-poldo-s\ a.html> and here...
Hi, just joined the group. I'm looking to buy my first scooter. Seen a PK125S for sale in pretty good condition for £795. Don't know that much about them and...
i posted this on the scooterbbs but didnt get much feedback. i was hoping you guys might give me some insight. anyway i got this 77 primavera vma2 from casa...
what "old polini is that"? does it have two boostports that are facing towards each other? you should check the prices for a new cylinder. it surely won't be ...
Price reduced: $150. Nice, all-black leather racesuit, with integral padding, zips at waist. I'm 5'11" and 185, fits me a bit large, so maybe 6' 200lbs? would...
Alright, I got my Primi running finally with new carb and transmission sorted. Runs great, but when the revs get high, or the throttle gets to a certain point...
Sounds like points flutter to me, however you could be running into fuel issues with that small pilot and big main jet. I'd bump your pilot jet up to at least...
I have nearly the same setup and could not get the revs I wanted evenly until I put the electronic ignition on it. let me know if you decide to do this as I...
top speed 55mph designed in the same year as the px the pk was a close match to the px but a small frame version. John Collier <jbcollier@...> wrote:...
Good engine - ugly body. You could probably get a nicer smallframe for the same money, something like a primmy or a kitted 50 or 90. Jim ... close match to the...
Too rich, try a 155 or 150. You may have to drop the needle a notch too. It all depends on local air density (air pressure + humidity). Clean your air filter...
I run a 12.5 (case matched Malossi). Remember it all depends on local conditions. By the way you should adjust your idle air screw -- it is an idle AIR screw...
Thanks Gery, JJ and John, I'll report back once I try leaner settings on the main and/or richer settings on the idle. I also seem to remember Francois saying...
There are repros available, I have two different kinds, but the feedback from customers is that they aren't very good repros. Supposedly, Saigon Scooter Center...
can anyone help out there? i have a vespa primmy 125 which i have done up as a 125et3 with the correct electrics and headset etc, the problem i have is that...
Have you checked your plug? Is it black and sooty or is it burning properly? By correct electrics, do you mean correct timing, or just the right wiring and ...
Hmmm, Your scoot sounds like a great project, at first guess i'd say you may need to have your carby rejetted to match your new electronic ignition system and ...
Did you clean out your fuel tap? Regardless, drain the tank again, examine for gunk in the gas, disassemble and clean both the carb and the fuel tap, and,...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
