-Thanks for the directions on the straps. That should be pretty clear and I was lucky that the brackets were not rusted tight so I should be in good shape on...
john, if you are stopping by on friday, wait and see how they are routed on my race car as an example. mine are shorter than a street car's would be! but...
... THE ENGINE COMPARTMENT AND THE TRUNK REAR? sitting in dirt but how far gone is it? like break in half kind of gone? enquiring minds wanna know..... ...
Phil, You should submit your photos of the 93b and caddy to the 'Ran When Parked' column of Classic Motorsports... you can dig up the submission info at...
Just forwarding on the info. General disclaimer - don't know them, etc. http://losangeles.craigslist.org/car/75712698.html I'd be willing to inspect it/take...
Last year I picked up a 1968 96v4 from a salvage yard where it had been sitting for an unknown number of years, and was also purported to have "run when...
With the help of my friends I was able to get those axle straps installed last evening. One side I actually did without removing the wheel. The other side I...
... Bushes for what? For the front/rear suspension? Some of these are the same size as on a c900 so these should still be available from the Saab dealer. ...
So I've got a good one for you all. Anyone have a source or good replacement for the little rubber grommets that fit over the threaded post which slips into...
last few days (no good deed goes unpunished) ok so the wiring is a mess , but i did go through everything and eventually had an idea of how to connect it up ,...
for any old engine in suspect condition siezed, (mainly free snowmobiles i use this on) but it is probally valid. get some bel ray chain lube , its not cheap...
... Pour in "Magic Mystery Oil" or a good penetrating oil. I bought a wrecking yard engine in Connecticut and one piston was rusted to the cylinder wall. They...
... For the front suspension? The OEM ones are very good and Poly won't give you a noticable change. All upper and lower control arm bushings for the...
For front and rear an they should be poplyurethane ! Regards Wolfgang ... http://biphome.spray.se/rolf.jensen/ssrspares/svensk/kaross/sida_kaross.htm ... ...
A former customer bought an Rs2 (Audi 20V turbo Euro only) Motor and harness sight unseen. It came to the shop a year before I started working there and it...
i would strongly reccomend NOT putting stiffer bushings in either front or rear of a 93/95/96 ! the rears if made stiffer transfer the torsional flexing of...
... Sorry, I just realized that classicsaabracing's bushings are nylon, not poly. So my previous message was sent in error. -STEFAN http://www.at-speed.com...
... Use the Larry "Stroker" Williams method: 1) mix up a brew of kerosene & light motor oil. I think Larry used a 50/50 mix. Dunno if he used drain oil or...
Thank you !Where do I get the original bushings? Regards Wolfgang ... ___________________________________________________________ Gesendet von Yahoo! Mail -...
Jam/Andy/Jeremy/Jon... Thanks for the tips. I knew it was something like that but wasn't sure which were the best fluids to dump in there. I may start with ...
front suspension upper and lower bushings are standard saab model 900 bushings right from saab. but the rear axle bushings for both the center bushing and the...
... The ones for the rear links are only about 3/4" or so in total diameter ... with a steel sleeve inside. There's not enough rubber in there for replacing...
How does the scoop for the heater air intake attach? I know it is with a clip of some kind but I have no idea what to look for. I don't have the clips because...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
