Well, I am no spring chicken, and it was the first (and only) car I never wanted to trade-in or upgrade, and when my 94 got totalled, I didn't consider...
My comment was based on a two car strategy! :) Obviously, most of the time lately, my SHO's won't win if there is real competition. Doesn't mean I don't...
Interesting tidbit on the Gen II starters over on the SHO Forum http://www.shoforum.com/showthread.php?t=73051 explains the difference between the 10 and 12...
Once again our own inimitable Kerby Haltom has left a priceless comment over the autoextermist http://autoextremist.com/mill.shtml Two thumbs up Kerby! Bill...
I haven't contacted him in awhile, but Kazoo is almost close enough for him to drive it there! Ron Porter ... From: D. Mallinson [mailto:dmall@...] ...
Hi all. Trying to figure this one out. It's on my '93 ATX Car wouldn't start, replaced starter. Battery weak, replaced with new one. Fuel pump works, fuel...
He says it doesn't sound like it's getting any spark. I will tell him we can still run the codes cold and see what we get. Thanks!! ... From: Paul Nimz To:...
We have spark. We did run the codes on the car cold. we are getting.........116 636 111 Can't find the first two on the list of code meanings that we have....
Went to put the car in park at work, everything on the dash went dead and then came back on. After work, it wouldn't turn over at all. Got all the dash...
From my SHO experience ('89, '90 and now a '93) That Crank Position Sensor is always suspect to me. This '93 was fine till one day I ran out of gas coming home...
From www.fordfuelinjection.com: 116 = ECT out of self test range 0.3 to 3.7 volts. 636 = TOT sensor voltage out of self test range. Both of those are from...
Codes KOEO or KOER 21 or 24 or 114, 116 or 636. System: Emissions/PCM/Fuel Codes: KOEO or KOER 21 or 24 or 114, 116 or 636 Problem: Engine/transmission...
Make sure both the small pos. and neg. wires are connected to the battery. Try unplugging the ECT sensor. Sergio ... From: Paul Nimz To: v6sho@yahoogroups.com...
Kris, have you guys tried starting with the pedal to the floor? It may just be too much fuel from all the starting attempts and holding WOT during cranking...
Hey Chris! We did try (a little) with the pedal to the metal but only for about 20 or so seconds. We could try again I guess, however it did nothing at all...
Are you getting dash lights now that the battery and starter have been replaced? I suspect that you have an electrical issue... Also, Check out the ECT...
Hey Ian! Yes, all the lights work. Andy is going to check out the ECT and the automatic car starter that is on the car. He had been pondering the idea that...
Hi Kris Does the car start if you jump it? If you can get it running, check the voltage output at the alternator using a multimeter and the voltage at the...
Ahh yes, that's what I meant when I said ECT sensor. I meant the low coolant sensor. My bad! Ian ... From: Jason Hartberger <jhartberger@...> To: Kristen...
Did you guys see this yet? http://video.google.com/videoplay?docid=3865827458415165033 Kirk J Doucette www.nesho.com SCT Dealer 1015 Welded- No failures _____...
Dammit! I got saliva in my keyboard..... Neil ... From: Kirk J Doucette To: v6sho@yahoogroups.com Sent: Sunday, March 04, 2007 1:45 PM Subject: [v6sho]...
