Not to many people on here have a 72 tm 250 they didn't make to many that year I for one haven't had much luck finding a pipe, not even one to weld up so I had...
Greetings Vintage Racing Fans, This issue MR runs the gamut of our favorite playground. I am pleased and honored to announce the addition of none other than...
I am looking for a shift shaft that will fit a 74 tm 125 or 100. Real good used or new. Has any one else had probs with these? this is the 2nd one I have...
I got 2 tm100s both came with bent shafts,i took both to welding shop and bent back. Bought new one off ebay [29.00] but thats for my restoration.Got to be...
TMs didn't have reeds . But , there was an aftermarket CO. who made a conversion kit . i just don't remember who they were made by . Ben <pyro500us@...>...
I think they were GEM conversions ... weren't they ??? A lot of GEM conversion I have seen were of pretty lousy engineering. REAL small throat sizes, etc...
I would imagine that the only after market reeds you can get for that one would be the Boyeson dual stage reeds . I don't think anyone else makes them for that...
ok thanks i will look into that ... that one would be the Boyeson dual stage reeds . I don't think anyone else makes them for that bike except Suzuki OEM...
I know this isn't a TM/RM etc., but it's a kissin' cousin. I need the larger of the two mag covers, the one with the clutch mech., not the smaller round one....
Is the bore on the cyl. fresh to the new piston, or is it just a new piston set and a used bore? I have that setup already. My cyl. has too much clearance to...
I have chossen to liqudate most of my vintage bikes, and leave the hobby. IU will need to seek someone to take over this isye. Barry, my 1st choice would be to...
Hi, all. I just joined because over the weekend I became the proud owner of a near mint 1970 TC120. It doesn't now run, but I am confident with fresh fuel,...
the shipping through d.h.l. ground was the cheapest at $12.95 for a total of $87.95 if it is better for you i can take paypal or you can send money order....
Well guys my new bike doesn't exactly fit the criteria for this forum but its close its a 71 suzuki its a 2 stroke 250 but it happens to be a t250 a road bike...
Hello to all TM/TS owners.I started this sight to share info with other TM125 owners.after a job change last year,I had (have) scant little time to devote to...
thanks Barry. I am still here, although not as often as I would like. I will not alienate the group until such time that a predecessor can be found. As I...
someone awhile back was asking for one of these---but never replies back to me---found a extra one today----as i perfer to use 79 rm 125 arm as they are...
hi guys great site i have been a member for 6 months now and would like to say thanks to barry and ahrma70m for all the great work and the time spent on...
Hello Everyone. Kennedy Meadows, California about 40 miles North West of Ridgecrest/China Lake, Ca. is the spot again this year. Approx 6000 feet above sea...
there's a kick starter in the "ts125" catagory on ebay,will it work on a tm125.it looks the same.I would think the spline size would be the same.thanks,barry...
