hey guys thanks for the advice on my tm project about the oil injection. so far shocks are done, motor pulled and ready to be gone threw, piston & rings,...
i just found one its got light rust on it but clean it up and and spray a clear coat over it and it will work great that bike must be a 73 model the 72s ...
wow great, how much$$ would lyou like for it? would you be willing to ship it to me, I could send you a money order, check ,or if you have a paypal account I...
thanks again david for the clutch arm, im a 170lb rider, shocks are stock and i ride pretty agressive for a 45 year old guy i guess! anyway how many ounces of...
with the fork springs out of the forks leave the caps off compress forks all the way down start with 140 cc of oil after you put it in work forks up and down...
I see you make friends everywhere you go Fred. Al ... forks leave the caps off compress forks all the way down start with 140 cc of oil after you put it in...
Gentlemen, A reminder of the 5th annual 100cc Vintage Nationals sponsored by "Strictly Hodaka". This event takes place in Greenwood, MO on May 26th. Those of...
Good morning gents, in the near future I'm going to install new swing arm bushings.This will be my 1st attempt at this,are there any specific procedures,or...
Hey barry,I just use a long 3/8 drive xtension and gently tap from the other side,there are spacers in the middle and the bushing on the end.When I do mine...
So I just pulled two TM125 motors apart that both had Webco heads. Neither had a gasket!!! I sure don't remember Webcos running gasketless but maybe I am...
thanks Ray,yeah I was wondering about the bronze one's.do you replace ... the other ... I do mine next ... would be better ... ways.Its been ... scramble here...
when i change the bushings i drill a greese fitting into the swing arm----just make sure that you put it in a place that you can get to it latter--i use an...
NEVER SEEN ONE WITHOUT A GASGET--but what i have noticed as of late in playing with my n/t 125 rms is that there are two gasgets listed--one thinner than the...
... I have a Webco catalog and they call for a (stock Suzuki)head gasket on TM's. Mike ... in playing with my n/t 125 rms is that there are two gasgets...
RAY--FOR SURE THEY WOULD BE BETTER--just do not know if they are a stock TC item--do you ?????latter--buzzymx45d---and ps please keep your weather out there as...
