i have circle f pipes on my tm lot less weight and they run great but i have a new jemco and i think it will be better cant wait till spring to try it do you...
has anyone replaced the stock 428 chain with a 520 chain on a tm125 and if so what did it take to do the swap? year and model of sprockets or custom parts?...
428H is the way to go---520 has too much weight and drag for a 125---thats only my feelings but have been racing them since new and had no chain problems...
jUST FOUND THESE AND THOUGHT I would let you know about these . I bought one and it's awesome ! This is like a canopy that you see the factory guys use at the...
... Yes, you bought it from me, I didnt know it fit a TM too. I have a bunch of TM & RM & TS throttle cables and pistons, check out my stuff. I am selling a...
Hello every one, I was getting started on a 1974 TM 125 engine. I also have a 1973 engine for parts. As I'm making one out of two, I see the 73 has a 16 tooth...
ray--usually all that goes bad is the bolt--thats still available for a few $$---LOTS OF THINGS ON EVIL-BAY cost and bid higher than what one can get it for...
Ray's 100% correct. I have also checked price and availability and yup..I got a quote of $69US brand spanking new..most assume this part would be obsolete but...
i just recently purchased a kick starter lever for my rms125 and it was $129 from mud and tar waurhope nsw .mick Doc <gotherat@...> wrote: Ray's 100%...
... have ... I have standard pistons for a '76 RM250 as well as about every other early RM, 370, 125 & 100, 80, 50's too, but not the rings. Also have pistons...
Hi Gang, Here's an instance where the power of a VMX group can help an honest guy out(see below). Here is a compressed link to a MapQuest map that shows where...
I just picked up a 1978 (I Think) Suzuki PE 175. The VIN # PE175-102412 can anyone tell me for sure it's a 1978? I will need a good kickstart lever for it. ...
Been lurking on the group for some time now... hoping one day to find my dream Evo bike; 1979 RM250N or 1980 RM250T... meanwhile... I'm working on a '72 Honda...
Greetings! If you haven't found them already, check out xlintperformance.com. It is a good source page and you might find some ideas for fenders and such that ...
I got a JEMCO pipe for my TS400 last summer. Very good pipe. Top notch craftsmanship. Seemed to be about 30% of the weight of the stock exhaust. If I...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
