I just replaced the cylinder head on my 1990 LX 1.5L SOHC. I can't seem to find the jumper connector to jump to set the timing. The files on the net for the 88...
Hi, Just joined this group, and I've got a question that maybe someone could help with? I have a 2005 Civic EX Special Edition, and I just recently put a set ...
Most of the 88 to 91 parts are the same. I know the fenders and hood are. There are some differences in the trim, but the main body lines are alike. ...
well i mistakenly overfilled my 2002 civic gas tank. now the check engine light is on.will someone please bail me out of this one. i disconnected the battery...
I replaced the distributor on my '91 and had to do the same. If your's is like mine it is a green connector directly above the right hand kick panel. Mine...
some times all you have to do it take the gas cap off and reseal it sometimes it jsut "sits" wrong good luck call hondaparts they will give a a few tips...
I am In Pennsylvania (southern) Jenni ... From: GMac999 <gmac999@...> To: thehondacivicclub@yahoogroups.com Sent: Thursday, January 31, 2008 12:34:10 AM ...
I just bought a 2008 Civic Sedan and my question regards the suspension. What should I do to firm it up? Yes it is an automatic and not an si. Front and rear...
I am looking to purchase a good condition Honda in which to install a 1.5 liter VTEC-E engine. This is the high fuel efficiency engine that came stock in the...
What did you do to install your new taillights? _____ From: thehondacivicclub@yahoogroups.com [mailto:thehondacivicclub@yahoogroups.com] On Behalf Of Drew ...
hi any body can advise me me? i just bought a 2nd hand honda civic 97 model and muffler is to loud because the they customize the muffler they chance the...
i would suggest a full suspension. if you want to go all out...or if you want to start off slow like i normally do...springs and sway bars and get a feel for...
Rick, Let me know the how the engine swap goes - when if you find one. Been looking for a decent 92-95 VX for years now. Next to impossible to find in decent...
adding a catalytic converter should help a little. I don't know that it will make a big difference, but in adding it, you'll likely have to shorten the...
OK thanks I'll look in the cabin under the dash passenger side. The 88 manual has it under the hood but I sure can't find it there. Bill ... your's is ... ...
The engine is from Japan. I assumed the Japanese engine would get at least as good mileage as the US VTEC-E engine. Do you have any information otherwise or...
Hello all, Just wanted to tell you about a Honda on E-Bay. I already own one of these, but I thought someone else might want one. It is a 1979 Honda Civic...
Hey all, I just joined the group and thought I'd send off a quick intro. My name is Dave, I'm from northern Virginia but native to California. When I lived in...
hello everyone i have a 98 honda civic. i need to replace my catalytic converter. i was wondering if i can get help on what i should buy and how much its going...
the first oil change should go a little longer because the factory filled the engine with 'break-in' oil, and they want that to be in as long as the oil life...
I have a 94 CX Hatch, bone stock, that I love. Ever since I got it, I found the road noise to be very irritating, but assumed it was just the econo-box...
Yeah I've had a wheel bearing go on my own a couple times. When your driving sway the car from left to right, if it quiets down then its a definite you know...
If you have a lot of road noise, you might want to try a product like Dynamat. It is a noise insulator that you mount on the floor, doors, side and trunk of...
Hello Everyone, I'm a new member. I used to read the Honda newsgroup, but I have been out of touch with the Civic community for a while. I have a strange ...
I am looking for a cheap car or motorcycle, somewhere in Indiana or surrounding states...any info would be gratly appreciated...as cheap a possible ......
Hi, Own a 2004 Civic Coupe ...value edition....and looking to dress it up a bit. Any suggestions of different rims ......preferably something factory....to...
ive got a problem removing my crank pully bolt,1.5 drivers side,ive had several acuras,and never had a problem removing for timing belt replacement,is this...
