Hello, How much do you want for the engine/trans? The email version confuses me greatly, so I have to ask here. Someone else also had an engine and trans. ...
... joint is broken the axle will spin and the car won't go. Putting it in 4wd provides power at the rear so that you aren't stuck. Jack up the front end and...
Gary how hard was it to change i am not real smart with cars ... From: gary carter To: thegreatsubarubratclub@yahoogroups.com Sent: Friday, October 03, 2008...
They are actually not that hard to replace. You need a 36mm socket for the axle nut. I would pop off your hub cap and loosen the axle nut before jacking up...
what all can i get the parts from ... From: gary carter To: thegreatsubarubratclub@yahoogroups.com Sent: Sunday, October 05, 2008 10:29 AM Subject: Re: [The...
http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&category=50446&viewitem=&item=140273340297&_trksid=p3907.m29 For the first time we at B&R sign and...
I am raising funds for The Leukemia & Lymphoma Society (LLS) as a participant in their Team In Training program and I'm asking you to help by making a donation...
Don't really want to do this...bought it from a friend last year, and immediately found two others that I drive more and this beauty just sits in the garage....
I am redoing my brat's exhaust system and I have a relatively simple question. The old exhaust system was a hack job and didn't have a catalytic converter. I...
... Typically the set up from factory are both the left and right exhaust ports from the engine both go into a pipe of their own. These left and right pipes...
So I've got a 2.2 from a 96 legacy in my 84 brat, I'm not running P/S but do need the alternator. Anybody know a part number for a belt that will run on the 96...
The usual arrangement is a y-pipe in the front that has a cat in it (cat 81 on only). Then there is a piece called a resonator. The muffler goes last. My...
The muffler is off to one side at the rear of the vehicle. It can't sit in the middle because of the 4WD. The 2WD Subaru's had the muffler more in the...
This beautiful little silver BRAT has 126,000 miles on it and is really a sweet car with no rust and all original paint and original stock parts. It has a 1800...
Top List Cheapest Cars to Insure http://autoinsurance-us.blogspot.com Top List Cheapest Cars to Insure, according to the Highway Loss Data Institute...
When I put the 2.2 in my Brat I measured the belt (only had the alt, no ps or aircon) and I think it was 68cm. Just grab some string, wrap it around and...
That must be a real kick to drive. Not CA I assume because of smog inspections, or does it just smog as the later year? Also, did you change out the...
Is it possible to put a hitachi in place of the carter webber? i got a hold of a hitachi but the intake is set to only have the webber bolt on it. do i have to...
The standard carb is a Hitachi, so there should be an adapter plate on the manifold for the Weber. If you want to run the Hitachi, remove the adapter, and it...
. I'm sure Burt is right. I ran a Weber on my '73 and had to mill an adapter plate to mount it. It sure ran great though. I have never seen one from the...
Where are you located? I have a number of intake manifolds, but it would probably be best to match them up. Does you vehicle have an underhood sticker. That...
There's a big difference between the Carter-Weber and the Weber. The carter-weber came with many California emissions Brats and is not the most desirable carb...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
