Please forgive us for any disturbance, but we have an important subject to address to you regarding FAITH, and we Don't intend to overload your email with...
Hey everyone, Im sorry to honor this with a reply but I had to, I have read once again how "fringe" muslims practice violence and had to guffaw at the...
all 80 4wd wagons had the same 1600 motor as the 80 Brat did, so bell- housing wise it should bolt up. the starter hole should be at the top of the wagon...
Very clean body, no dents in front or rear bumpers, high top canopy, front A-bar, and rear seats with headrests and seatbelts. Needs TLC, currently runs, and...
Just an up date on my 1980 wagon 4 speed in to my 1980 Brat. The trans is the same but the tail shaft is different. I had to take the tail from the brat trans...
Ken, Trying to find info on the 3.7 and 3.9 ratio sube diffs. I take it that the sticker on the rear of the diff is missing? Was trying to find turn ratios, ie...
..but a buddy of mine came into a bunch of Subaru air filters with some other stuff he bought, and is looking for folks who want 'em. He'll sell them in...
hello everyone. i just joined the group. been into soobs for a while. i am looking for a clean gen 2 brat body, running condition or interior condition not...
Hi Fellow Soobie-lovers! Anyone out there have any connections/sources for rocker pannels for an"87" Brat? Any help would be VERY appriciated!!! Thanks!!!...
Try here, I think the wagon has the same wheel base as a Brat. http://www.rustrepair.com/app2/onlinecat.htm?p=sm-subaru [Non-text portions of this message have...
I have an 85 and a 86 brat. The 85 is a gl with stick, and the 86 is a turbo brat, auto, less engine. Both need work but are solid. If your interested contact...
Thanks!!! I'll give it a try... And thank you for the quick response!!! ... From: Glenn & Kathi To: thegreatsubarubratclub@yahoogroups.com Sent: Sunday,...
Assuming that you have the driveshaft to the rear diff in on this. Raise one side of the vehicle off the ground, one front and one rear wheel up in the air....
I have an 82 Brat that has rust along the bottom and the fenderwells are rusted through in the bed, but I have a lot of extra parts to go with it including 2...
where are you located? James Cannon <filvergish@...> wrote:I have an 82 Brat that has rust along the bottom and the fenderwells are rusted through in...
Greetings from Canada. We can make up rockers for the Brat for $90. each side. See our web site www.subarubodypanels.com We have made up a set of 1/4 panels...
I'm located in Illinois right accross the river from St. Louis MO. ... From: william kenyon To: thegreatsubarubratclub@yahoogroups.com Sent: Wednesday,...
roger, thanks....too far for me...i am in Connecticut... James Cannon <filvergish@...> wrote:I'm located in Illinois right accross the river from St....
Hi, New to the list. Have a 98 Outback but would like to add a Brat to the stable. Looking for a gen 2 with low/high range. Seen a few on Ebay but they are...
I have a 1982 Brat with dual range tranny, 4 spd. Has rust along bottom, rusted through rear fender wells, couple of dents in front fenders. Was running a...
I have one that is not too banged up but has rust along the bottom that is through in some places. It's not running at this time and has a lot of extra parts...
seen a couple along the hiway south of dallas heading to san antonio before belton. Not real sure of where haven't been that way for two years maybe three but...
all 1980 4WD's were 3.90 final ratio also, all 4 speed 4WD tranny's had a 3.90. the 85+ 5 speed 4wd Turbos had a 3.70 ratio ... the ... the ... anyone ... ...
... desert where it remained until '96. except for the last two years it has always been garaged.. it has been a daily driver and has good mechanics, but...
