i have built a number of /2 BMWs for sidecar use and now want to try my hand with an other project. Have a couple of good running R50/2 motors and a very cool...
I need a stator for an M1M 12 volt, I have the armature assembly. Dose anyone know where to get one? Thanks, P. Stout [Non-text portions of this message have...
I would think Marcus (Long River USA) or Fred (CJ Parts Depot) would have one to sell you, I could loan you my spare but I'd need it back. Richard I need a...
Thanks, for the offer. I am trying to finish a build, and I am finding small parts that are missing. The closer I get to completion the longer it seems till I...
Where are you? Freddie is in San Jose and Marcus is over by Denver I think. Richard ... finding small parts that are missing. The closer I get to completion ...
I guess Marcus will be closest until Jim gets up and running in Florida. Thanks to Fed Ex and UPS anybody that has one could help you. You know how to get in...
Brad, I'm not sure what you mean when you say you're not getting power to your ignition. If you turn your key and there's no power to anything (lights, starter...
Hey gang! Just a couple of quick questions about my M1M 12 volt. First, I'd like to remove the wheels to check the brakes. Looking at the front wheel, it seems...
I'm guessing you mean that Fred and Marcus did not have a 12 volt stator on hand....those six volt fans, I don't know about them. If that's the case just order...
I'm assuming you have not found the toolbox yet? http://www.changjiangunlimited.com/tech.htm If you check my hints on fork repair the first paragraph may help...
Marcus was visiting China a bit ago as I was chatting with Clay and he had recently left, and I believe Fred's territory is the entire west coast and Hawaii in...
I don't have a clue. I ordered a number of spare parts with my bike and paid for it all in one invoice. I just left Fred a message he will probably get...
The problem was a funky connection in the wires just beneath the switch, I wiggled them and the lights came on. The bike started right up. Now the headlight...
All CJ and other vintage bike owners should always carry a 6-12 volts light tester & a multimeter. With these tester you should be able to solve almot all...
Hi, My very first conversion was a CJ powered by a 1951 (I think) R67/2 motor. I sold it a few years back and the present owner still posts on this Group. It...
And I'm that owner :-) I was outside just yesterday fine tuning the carb adjustment and performing a periodic fuel filter check/replacement. The bike ran like...
Question, my bike seems to feed gas to the left carb much quicker than the carb on the right, when I am priming to start. Is this common? Brad Richard Cook...
Hi All, Anyone have a couple of CJ wheels for sale in the US? Preferably on the west coast, need them for the M1M I am trying to put together. Many Thanks...
-Remove the petcock, clean it out, make the sure rubber gasket is cut correctly (the two holes), and run a drill thru the the "y" tube that is on the bottom of...
-I have a set that has cast iron drums with rubber. Brand new. They are original and probably wobble. I also have a set with cast iron drums that have been...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
