No price, and it doesn't say if it is NiCD or NiFE. From what I know now though, if it is NiCD, it could be valuable. If it is NiFE, don't know. With the ...
No price, and it doesn't say if it is NiCD or NiFE. From what I know now though, if it is NiCD, it could be valuable. If it is NiFE, don't know. With the ...
I have finaly installed the 30 ,, good, used,ex wheel chair, group 24 gels.I have no charging cables,I would like to aquire at least one cable to be able to...
IIRC, NONE of the TEVans were set up for AGM's. The profile is in the firmware in the charger. The charging cable only provides the AC power to the charger,...
I wrote software for Horizon lead acid batteries back in 1995 and I believe they did some testing at Chrysler. They never provided a van with lead acids for...
johnson controls bought this tevan with no battery pack to test their AGM battery line. The AGM line was sold off that same year. I have been unsuccessful...
Enter your vote today! A new poll has been created for the tevan group: Is your TEVan operational? o Yes o No To vote, please visit the following web page: ...
tevan@yahoogroups.com
Aug 14, 2008 2:23 am
315
I only voted 1 time, for 1 non-running TeVan. But, my vote actually represents 3 TeVans. One belongs to Dave R, and the other 2 belong to Charles R. None of...
Hello All, I'm a new TEVan owner. I bought the one off the Austin EV Tradin' post. Please see the photographs. Few questions for everyone: 1. Parts, I'm...
... You can change the extension to .txt, since it's really just a text file. The charging software allows you to see some of the parameters for charging, like...
Ok, Yet another newbie question, thank you all for your patience. Just had the reverse switch repaired on my van and now when I step on the brake with no key...
Nope, you've got a sneak circuit there somewhere. The pump should not come on unless the key is on. Dave ... From: teaandbicycles <disagreeable@...> ...
Dear All, Yesterday I modified a 1994 Nissan Maxima heater/AC blower motor to work as the TEVan battery blower. Blows strong, snug fit. Began charging at...
I don't know any history on your van, but I suspect that it sat a long time and the batteries are not fully recovered (if they ever will). I'd recommend...
I don't quite agree with that. Flooded NiCd's don't have any memory, but they do like to be occasionally pulled down to 1.0 VPC or in this case 180 Volts for...
The following tevan poll is now closed. Here are the final results: POLL QUESTION: Is your TEVan operational? CHOICES AND RESULTS - Yes, 3 votes, 50.00% - No,...
tevan@yahoogroups.com
Aug 29, 2008 1:47 am
324
Sorry. I thought it was a NiFe van. Then, he would need to take them to flat and recharge. ... From: jwolfe@... <jwolfe@...> Subject:...
Alex, I do not know what the manufacturer recommends for the NiFe's but the characteristics are similar to the NiCd's. Without detailed knowledge as to a...
Thanks again, The charger isn't going on though. No left marker light. Could be a fuse, could be the charger, could be the service. I have to get a little...
The left marker light is turned on after the green wire integrity test by pulling the -12V side of the marker light low with one of the 12V relays. That low...
The advice that I gave about driving the batteries to near zero is what Dave R. here in Atlanta was trying to do with his TeVan batts. When he got his van,...
Hey Jim, I usually plug the TEVan in and then turn the outlet it's plugged into on. I just went outside and turned the outlet on and listened for the ...
Alex, The first relay you would hear is the 12V relay for start lockout.. ie: won't let you drive off with it plugged in. You should hear that when you plug it...
The advice that I gave about driving the batteries to near zero is what Dave R. here in Atlanta was trying to do with his TeVan batts. When he got his van,...
Hey Jim, No relay sound when I plug the charge cable to the van or when I power it up. Completely silent. All of the fuses look good. It has the Square D...
Today my friend, and electrical engineer, John came by and unplugged the power to the MCU, opened up the MCU and took a look inside. He then reconnected the...
A 1994 Nissan Maxima heat/ac blower with 2mm sanded from the inner edge of the fan, a single new hole drilled on the mount plate, and the electrical connector...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
