Ou should leave the old cassettes alone and get a cassette converter and plug your ipod into it instead. Or even get an FM transmitter for you ipod and skip...
Yes, it isn't used for anything with the electric pump. Stan http://www.oregonvintage.com Scooter Parts and Service Tips MRP & PFS Authorized Dealer ... From:...
That's the best plan. If I had to guess, I'd say 5/32" or 3/16" but taking a sample is the way to go. The fuel line is 1/4". Stan http://www.oregonvintage.com ...
I found the radio, speakers and on/off audio control knob to be POS. I removed it all. I cut the two power wires (red and orange) and installed a toggle switch...
While i was trying to close the under seat door opening I managed to snap off the little hose connector on the filler neck. I went to Mr Scooter (sadly) to get...
I just replaced mine last week. It is a 1992 Honda Helix part and it's called the radiator neck filler. You can order it from any Honda dealer in your area....
The part number is on my web site. Go to the Scooter Repair Article page and then the one call Part Numbers for Common Items. But, the Honda part will cost...
Here is a link with the part listed. The part # is right beside it. I was right, it is number 6 on the list. You should be able to order this from any Honda...
Besides Tank Scooter, I own a small scooter as well. I was driving my Vento Triton 4 50cc, and the head lights suddenly went out. It was in the middle of the...
I don't own a vento, but if they are anything like a tanks electrical system, then i can take a few guess. but first... the running lights on tanks are run...
Is everyone going with the Strictly Motorcycle oils or are your everyday car oil doing the job fine? No place local to purcase, so I would have to pay the...
Loose wire that powers the headlights. It was comming loose that is why they kept going on and off ntil the plug came out completely. ... the middle of the...
Automotive oil is just fine as long as you do not have a wet clutch. Tanks do not. Many use synthetic oil after break in, about 1000 k. David Sallee...
Auto oil is working fine for me. Brand is unimportant as long as it is a brand you know. Synthetic auto oil is nice, but not absolutely necessary. Change it...
Thank you very much for your reply! Here's what I did: I took apart the left side that included the high/low switch, and there were no loose wires. I also...
Andrew, thank you very much for your reply! The noise that you heard while you were riding might have come from the CVT unit. The same thing happened to me....
Thanks Stan, It looks like the large version voltage regulators are in short supply, does anyone know a way to use the smaller one in a Tank 2005, 150 Touring?...
Nope. You need the Tank type regulator or you risk serious damage. Stan http://www.oregonvintage.com Scooter Parts and Service Tips MRP & PFS Authorized Dealer...
It could be the switch itself is bad. ... wires. I also went another step and took the right side apart where there is a headlight switch, and no loose wires...
Time to dig out the VOM (volt-ohm meter) and check to see if the switch John mentioned is working correctly. If it is, check the wiring again with the VOM ...
Jim is right on here! I have seen some wire terminals crimped on without stripping the insulation back and it can make intermittent contact. When these...
Kinda on the subject... I have a voltage meter inline on my scooter. I have noticed from time to time that even though the battery voltage is quite low (after...
got my tank 150cc touring scooter and it runs great and with a few small bugs worked out, has been alot of fun. The only problem I'm, still having is the...
I used red lock tite on the threads on my Tank 250 and they have stayed in place. You should apply to the threads and then let dry overnight. I also balanced...
Okay, you peaked my curiosity, Dyna Beads? I looked on their website. How do they work? Are they easy to apply? I have a TT250 also, did you get the 1 oz or 2...
On the website, Innovative Balancing, the balancing process is discussed. I thought that they were really easy to install. I did not have to remove the wheels...
