... His is a '92 ZX7R K2. From 89-94 the base model was called a ZX7. The trick race version bikes, like the K1, K2, M1, and M2 got the ZX7R designation. Then,...
Turned out alot better than the ORP video. The camera is straight, I didn't loose footage, the sound is way better. Charlie and Shawn both have it downloaded....
I pulled the rear caliper off, opened the bleed valve, and pushed the piston back in. After putting it back on the rotor, I replaced the old fluid, it looked...
I finally bit the bullet and turned it in to have the carbs done. The stock jets were a 12.5 (whatever) and it needed a 13 with the pipe, but the yahoo before...
I removed the rear fender, and it looks sweet! These two brackets are actually part of the frame. I'd like to utilize the back holes for blinkers and little...
Build thread on Boiseriders.net <http://boiseriders.net/sportbikes/6452-1987-ninja-250-project-thread.ht\ ml#post102548> [Non-text portions of this message...
I got the video edited and uploaded. I didn't use it all, but I used parts of a three videos to piece together a 10 minute video with Trailer, Shawn, Flip, and...
Charlie cut some round stock and drilled and tapped it, then welded it to the VTR swingarm. If you dont have access to that kind of stuff you can go to the...
The drill and insert route looks good. For around $150, I could get spools and a rear stand, that's pretty reasonable. I don't think that would weaken the...
About the same unless your bike stands about straight up like Crashmasters. I wouldn't leave it in a public parking lot on a stand unless you want to buy a new...
Hi guys. I fell in love with the '09 white gixxer at Laguna Seca (fabulous races!), so I'm going to consign the yellow '08 at Coos ATV & Cycle. Just wanted...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
