>Powerslave getting civil in his reply's?<<br><br>What kind of medication is his wife giving him?<br><br>Compared to when I first joined,he's practically...
Dr.butts is a massage therapist?<br><br>Wait till mensh finds out.<br>He's gonna have a melt down!<br><br>I can just see him now,drag racing his little tracker...
A massage therapist is all?! We have those down here!<br> But an auburn haired garage owner. I can dream can't I?. <br>Besides, cute IS cute. Even if she were ...
How in the hockey-puck does one remove the rear brake drums???? I need to replace a wheel stud, and try as I might the brake drum won't come off!<br><br>The ...
Can a swap from a Automatic transmission to<br>Manual 5 spd be done, I have all parts except<br>for pilot bearing, clutch flywheel, all other<br>parts are from...
My Haynes manual says (chap 9, sec 6) in a 'note',<br> "If the brake drum cannot be easily pulled off the axle and shoe assembly (see chapter 1), make sure ...
It should be an easy swap. I did the same swap but in reverse, I replaced the 5-sp w/ the auto. I replaced the tranny and trans. case together and both the ...
I believe I typed it in a WHILE back, and will not repeat the message. <br><br>What I did there, most is classified, but I elaborated on some aspects. I do not...
My brake drums come off when I remove the four nuts that hold it on. THe stuts are part of the drum, which I guess you know that.<br><br>Seems kind of cheesy,...
You you may have to use a rubber mallot once you loosen up the four nuts. My driver-side drum was on pretty good, so I used a mallot, banged on ot enough...
the reason i said that is that the new models actually stretched the dimensions a bit, wheelbase for sure and maybe track too. of course, all 4-drs are bigger...
Today I loaded 8 twenty pound bags of landscaping stone on my<br> Trackers cargo rack.<br><br>wow. bet it was squattin' low.<br>i use a trailer for big loads ...
haven't tried this trick on mytrack, but some wheel drums have a hole in the back where you can stick a screwdriver in and loosen the shoes by turning the...
"What I did there, most is classified."<br>"I do not want to RETYPE, as I do not want to allow more specifics then what was originlly posted."<br><br>oh, I get...
I have one of those racks that connect to my receiver also. It comes in handy.<br> My receiver is 1 1/4". Can't find to many options that fit. Most are for 2"....
I killed the sticky stuff! Had to disassemble the throttle cable linkage at the throttle body. Took the double spring assembly out and cleaned/lubed it....
cool Islander! I have never been inside my throttle body. After seeing what was wrong with yours, do you have any tips how to prevent it from happening again?...
Geez, don't know what to tell ya. I think it's of of those freak problems. There's quite a bit of grime that accumulates back there so for prevention's sake I...
>>><br>On Sidekick and Tracker models, to retract the brake shoes, pull the shoe hold down pin about 1/4 inch (see illustration 6.4b). The drum should...
>>><br>My brake drums come off when I remove the four nuts that hold it on. <br>>>><br>I tried that, and the penetrating oil thingy listed in...
>>><br>some wheel drums have a hole in the back where you can stick a screwdriver in and loosen the shoes by turning the automatic adjuster and ...
Hoo! I just turned 143K (miles) today and ot celebrate I changed the front and rear differential fluids. I also did the PCV valve. :-) Now if only I could ...
