Art, Which S&S carb do you have? The E model would be a good fit for your engine, B is tricky to get running but should operate well once tuned right, G model...
1 st off talk to a new mech. s and s carbs. there is a oiler that oils the prim. chain from the engine oil u can run points or elc . eng. get a 2nd mech. to...
In a message dated 5/5/2008 4:06:45 PM Mountain Daylight Time, picwick44@... writes: are you running a compensating sprocket or straight shaft type? if...
In a message dated 5/5/2008 4:07:19 PM Mountain Daylight Time, bigbood1@... writes: 1 st off talk to a new mech. s and s carbs. there is a oiler that...
yeah, try runnin her a litle loose or check that chain... I've had the same shoe for like 10 years, it could be replaced, but only shows normal wear. I'd...
I run a belt on my shovel and I love it. Call Phil @ 928-649-2836 or www.supermax.net you won't regret it. Ride safe, Brad --- On Sat, 5/3/08, Antonio Smith...
... it's the later of the two was the sprocket oversized? too much pitch maybe from front to back or maybe your chain is just wornout & has cutting edge...
... your ... tuned ... a G ... see ... http://www.jpcycles.com/catalog/2008HarleyFirstEditionCatalog/full.asp ?page=279 ... thus ... to ... have ... _really_ ...
Hey just got mine running same problem the shoe is gone,,I was wondering why I did not have any adjustment ,with a new chain,Daaa, I must have inhaled way too...
Primary is chain on the 84's with belt drive ... ____________________________________________________________________________________ Be a better friend,...
Thank you all for the advise. I know they eventually get eaten up, but I should not have gone through 3 in 6 months. Yes I have in on right (Im not that...
... knowledge to ... NE, ... for the Evo ... early shovel, ... But everyone ... of grief ... fine. ... on family ... Ok, I had a run-in with a Hyudai. The...
They are the cheap baffles that have triangles punched out of them to cause the flow of hot gases to swirl around them to give you back pressure. The triangles...
Check the alignment of the sprockets as per manual. You might get some interesting results.By "interesting, I mean that you might find that your front...
In a message dated 5/7/2008 10:00:57 AM Mountain Daylight Time, spudz46@... writes: I put a belt drive in mine last year and I LOVE IT,you will have no...
In a message dated 5/7/2008 9:59:35 AM Mountain Daylight Time, axndk@... writes: Primary is chain on the 84's with belt drive This is problematic really....
In a message dated 5/7/2008 9:58:15 AM Mountain Daylight Time, rosseddie@... writes: Which S&S carb do you have? The E model would be a good fit for ...
No Helmet Law in Oklahoma. Barry Yaffe www.yaffeco.net <http://www.yaffeco.net/> This message may be protected by the attorney-client privilege and other ...
Hi, I have a problem. I ordered a set of new cylinder base studs, and of course, threw away the old ones before the new ones arrived. While calculating the...
What is the proper way to run the small oil line, from the oil pump to the primary chain housing? I have a note that, I think I made for that line. Line runs...