Hmmmmm. The battery drain *could* be from the trunk release continually firing. Solenoids do draw quite a bit of current, but you didn't say how long it...
Appreciate the input Leigh. About 24 - 36 hours, and that battery has been drained. Can be recharged within 1 - 2 hours, but the battery was purchased new in...
Hey guys its me. I havent been using my maxoma because its my back yup car but i still use it from time to time. Today i fixed aux fan however.. the car runs...
If the MAF is known good, I would suspect an O2 sensor is going bad. There is only one right at the downpipe where the front manifold and crossover meet. S ......
... Lets see some final paint pics! Primer is boring. The "300ZX Project" consists of an engine at this point, right? No actual 300ZX? He He. On a related...
har har har. =) I found an ECU also, but the hard time is coming up with the money and the custom front motor mount...everything else is ready to go, I gutted...
Well folks, I just finished the last layer of clear coat (4th coat) for my car. The car looks great, couple of runs on the clear but everything else looks...
Man.. that darned mazda.. i hydrolocked it and then after fixing it i had some short or something. Anyways the mx3 is making me sick.. i drove the maxima .....
A fellow Canuck! Try posting it on www.torontomaxima.com , someone there might be interested. Some pics might help the sale. I *might* have some interest...
Looks good! No, really! What'ya going to do with the grille? The BMW lights were a fair bit narrower than ours, like an inch or so, IIRC. You going to try...
I got some fiberglass matting, resin, and spare time. =) I plan on making a custom outline grille, that will fit around the edge of the gap and possible...
UPDATE: Have not had the time, or taken the time, to inspect the door lock/cylinder. In this interim period, I simply disconnect the negative battery cable;...
My father and I finished fixing the many problems the max had. We changed the front and rear motor mounts(both shot to hell) and both transmission mounts(in...
Sounds good roger, my car will have to be going through some of what your car already went through. How many $ this project set you back? -d ... water ... did ...
not that much due to the fact that I had a lot of the parts as spares at home. of the ones I did buy, I spent around $300-400 with the engine and transmission...
Where exactly is this plug? On the Haynes manual, it says the oil filler plug is on the 89-94 transmissions. Sarin, did you have that hole b/c you swapped to...
It doesn't matter what gen tranny you have. The fill plug is on the front side right by the front tranny mount. You can't miss it as it's got a square for a...
Where is the PCV valve located on a 1988 and how big of a pain is it to replace? Thanks! --Ray-- __________________________________________________ Do You...
From what im reading, a lot of you have custom CAI, or Strut Tower Bars, yet nobody is explaing how they created them. I got info from another site, to use 93...
If you use the Search Feature for past messages, you would see this message, among many covering strut bars and CAI. Also available is the Photos section,...
...so for the weekend, Pick a Part is having a glorious 3 day 50% off sale, so I decide to go shopping. My car has two wire outs for a CHTS, but in place of it...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
