Did anyone every buy KALSC's Max? I was curious as to why he was selling it and if he ever did (wanted to know if he ran into any heat problems). I was...
I bought/buying most of the turbo components off his car. Though I'm redoing the piping to put the turbo over the tranny. Still depending on which IM he sends...
Wow, Sarin's moving up in da world pretty fast...must be that IT degree. =) Are you going to be using his modified front mount or use your original? -A...
...but U-Haul. My bud has a body shop and he has two of these, though he's using the front end on the non-running one to put it onto the running one. Anyhoo,...
Hello group! I have a vg70 v6 in a 1987 Max that starts hard (about 2 try, sometimes 4), and idles rough. Does anyone have the voltage specs for the MAF? The...
Not entirely sure yet, but I would like to stick with what I have. We'll see once the kit comes in as it's probably gonna take me a good month or 2 working on...
Dude, you can pick up an ECU for around $50 at a junkyard. Then you can keep the car, or if you still want to sell it, at least you can say that it runs....
Hi there, I have the same problem too with my 87 gxe, i replaced that air sensor thing on the rear center intake manifold to no avail. my next replacement...
Mesinspector, if you are talking about the MAF (Mass Air Flow Meter), then the screw is either there or it isn't, from the factory. Nobody drills holes in...
I ran a 16.3x in my 87(full interior), and I have a crappy hot idle, but once you are on the gas it runs strong. Also the thing you are calling the air valve,...
I asked this question on the .org but no one has a defenitive answer. I need to replace my fuel temp sensor (on the FPR). My spade connection is broken off...
Hi all, Just wanted you to know my son's 86 is running beautifully! All your advise got it into working condition and he loves it. I read your posts everyday...
Carson, I haven't done this personally, but haynes recommends replacing the whole unit. Daniel. cardana24 <cardana24@...> wrote: I asked this question on...
Everyone, Thanks for your help. Had the TPS ill adjusted. That help considerablly for starts. I performed the mod on the AAR not MAF. Works great. Question,...
ahh, i just could not remember what that drill it out and put a screw in it thing was called, the aav. thank you... anywhoo, i replaced this aav with a donor...
i encountered more problems now... my dad kept saying its the battery that wont make my car start but i knew he was rong but i figured i might as well proove...
Yes, you should follow the instructions on the can for the intake/TB cleaner. If it says to do it while the car is running, then it has to be running. You...
Your distributor cap should not move at all, check the two bolts that hold it onto the distributor housing. One of mine was stripped out, so I put a nut and...
What was the weather like when you ran that time? ... idle, ... rear ... things ... sensor ... the ... My ... the ... car ... the ... will ... i ... resistance...
yeah I know that, I was wondering why they recomend that...so I was hoping to find someone that had done this. My concerns are, it will just snap off if I try...
is your car throwing any codes? Also the AAV you got from the junk yard could be a peice of crap too...they go out often in our cars. I would check for...
you are on the right track I think...it sounds like you just have a bad connection on your battery terminals....just take a wire brush to them, then put them...
It was about 50 degrees/sunny/not very humid. It was the same day Mardigras ran the 11.5. I am pretty sure I can get a high 15 if I just cut a better 60', on...
that aav just may have been a junker, so now.. lets see... what is this magical secret drill a hole and screw it.. aav fix that i have been told about? what...
Ray: Note that corrosion can occur on the battery cables below the surface of any kind of plastic coating on the primary or seconday leads and cause the same...
thanks alot eric... i sanded down the battery terminals and the battery posts today and that fixed battery problem ... __________________________________ Do...
I ordered a HID kit for the volvo. If I get good results, I might invest in a HID kit for the maxima. Some of the pluses for this is they use denso ballasts,...
my battery cables are sanded and hooked up nice and tightly... i tried to jumpstart the car today and i figured it would need a little more time to charge...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
