Hi, Yes, That is exactly what I did. The new battery was only $12.00 US here but the new case would be worth the money. The 250cc that the battery original...
Hello All I have a recurring tire problem. When I or the local Honda shop change the tire tube I always get a leak at the valve stem. The stem appears to be...
Those stems have to be depressed down into the tire to allow the bead of the tire to fully seat witout pinching the tube at the stem. It is a pain, especially...
Hey there Joe, The hose on my pump was bad and after some searching I found new ones that work. They are shorter than the original hose and the fabric covering...
Does anyone know where to get the rubber boots that go over the outside coil terminals. I have two of the four but they are very old and hard and should be...
maybe the valve inside the stem is not tight enough? there are two, usually, nuts on each threaded part of the stem. One stays on the stem on the inside of the...
Just thought I would add my experiences with tubes. When I have put the nut on the inside and one outside I have ended up with a failed stem shortly down the...
i put the stem in first, dust a little baby powder inside the tire and carefully work the tube in between the tire and rime..on a tire that small..you can push...
I am wondering on the all state 175 i have the engine serail number but I cant seem to find the manufactures, are they engraved on the frame or were they on a...
The motor looks to be either a Compact motor or a Sport 60/Cheyenne motor without the shrouding. The model number on the 175 should be on a plate rivited to...
Hello, I am working on my prize, a 1963 sears allstate compact that was given to me as a project. I have the manuals and have started reassembling the engine,...
Joe, What's the part number? Also, what number is it in the parts book - like, number 27.....and what page is it on? I've quite a few NOS parts, but they're...
thanks Bill  Part # 900.6104, page 46 identified as #5 and 47 listed reference number 5 in Gearbox section.  This is for model #810.94380  Please let...
hey, i dont want to high jack your post but ive got a 65 compact and im ready to split the case... did you lose the bearings or were they messed up?????? ......
no problem, they came out once the case was split, it was the opposite side from the 16 and 14 bearings side. There is one lone side of bearings with 14 in it....
Ok, we have expert help for installing inner tubes but nobody knows about carbs??? The problem has been resolved so if anyone else runs into the same problem,...
I'll take a stab at this carb question. In the old days when these bikes were new, gasoline was gasoline. Nowadays, gasoline is a chemical mixture os a little...
I have found this website helpful. http://www.bingcarburetor.com/ ... bikes were new, gasoline was gasoline. Nowadays, gasoline is a chemical mixture os a...
Interesting bike but I'm trying to place the SR part of the model. Does anyone know what SR means or what parts make up that model?? I have an Italian Gilera...
Hi all, friend wants to change out his late 250 rear fender with the big Lucas type tail light to the early one that uses the small moped type tail light...
I think the SR stands for Sears Roebuck, The SR was also used for other makes of bikes that Sears sold. I think the sears gilera SR 124 5v would have been a...
Thanks Bill, I got a new petcock from Motorwest. I may be interested in one of your anyway. What would you take for one? The carb is fixed. The obvious...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
