hi all can anyone tell me if the ti engine is a none interferance engine as my timing belt jumpped teeth thanks too a failed serpintine belt at 4k i've put a...
... interferance ... just ... lucky ;-) ... read about ... Indeed, it is an interference engine, so, yes very lucky it didn't jump more than a tooth, otherwise...
Hi All I am a new member and have just been given a 620gsi with a few problems but full service history the main problems are dents but I have another and that...
Hi Daniel I think i've just had the same trouble as you except that my car squeeked at any speed. I then rang my mechanic mate who said it is probably a wheel...
Can anybody tell me if they know of anywhere i can buy a rear wheel arch for my 600? I don't want to have to buy the whole rear wing panal at £240.If not,...
Hi Daniel, Check the brake pads, but don't rely on looking at the outer pads, especially on the rear as the inner pad can be shot but the outer still shows 2-3...
Hi Folks, There I was driving along quite happily down the M40 in my 623SLi, not even breaking the speed limit or anything, when suddenly out of no where a...
Hi Elvis, A couple of things to check, the first would be for wheel balancing, the weight might have been knocked off, simple solution, wheels rebalanced, does...
Probably lost a wheel weight, doesn't cost much to get the wheels balanced. Could have put the tracking out or worse though, have the garage look to see if any...
Hi All I have a slight problem with my car when I drive to work in the morning I park the car up and it will leak a small amount of petrol from under the...
The fuel lines (and brake lines) run under the car from the fuel tank to the engine close to the centre tunnel (ie close to the exhaust) and it doesn't take...
I had a 620 sldi it was the best car i have ever owned, it was damaged in an accident and i could not get the car from the insurance company. I am looking for...
did you get an answer on the aerial? mine too is stuck. Ive changed the cd player and the aerial doesnt work If you get an answer let me know please. Rich ...
im interested in putting body kitting my 600 out does anybody know of a decent place to get parts preferably in the midlands. Thanks Rich ... Do you Yahoo!? ...
Do you hear anything when you power off? If you dont hear the moter trying to work you need to check the fuse and all connections. If you do then you may need...
Anybody got any tips or hints to make changing the clutch on my 1999 620 any easier. I have the Haynes manual which makes things pretty clear. Rob This message...
... Er, you need to wire the REMOTE line from the ISO block, into the REMOTE line on the rear of your stereo. The aerial won't go up unless it receives 12v...
Hi all Just bought the above vehicle very impressed with the performance of the engine but need some help with parts... Is anyone in the London area breaking a...
... I was under the impression that all the 600s had the intercooled diesel engine, nethertheless, here is a pic of what the intercooler should look like (its...
Thankyou so much for your email, i thought that was the case that they were all intercooled too but it was a rover forum which said otherwise(?) Anyway off to...
I have an ABS problem ! The fault code being produced is 15 but this is NOT listed in my fault code list !! 1. Does anybody know what fault this relates to ? ...
If anyone is interested my ti is for sale, I've got it on Autotrader atm for £1795 but I'm open to offers. 1996 N-reg (early version without body coloured...
Many thanks for your reply, I have realised that the fault code which I have been looking at is three lots of 4.1, front r/h sensors problem !! ... past :)...
Give it all a good clean. Faults of this nature are usually caused by dirt on the toothed ring, and/or duff connection(s). It's unlikely (though it is...
The back box on my 623 GSi has just started blowing. I'll get it replaced at my local exhaust centre. The question is, are the chrome tail pipes part of an...