Does anyone have a NOS cam chain they can spare for my Wildcat project which is moving toward completion? It seems the supply of original chain has dried up...
John, I had some made up at a local bearing supply house some years ago in Shreveport, LA. Never had any complaints about them. I would have to try to dig up...
I seem to recall there was a recent thread about unavailability of sub-3.00 19" tires here in the USA. Before you guys lace up 18" rims you should get hold of...
Hope I'm not bringing up an old thread that's been thoroughly explored before, but I discovered the same thing today at my local bearing house; i.e. the OEM...
130mm, Seen Aprilia & CEV Mike lotusnutt wrote: hi all, what size/type headlight was used on early/late lusso veloce/ speesters?? Cev,Aprilia 130mm or 150mm ??...
Glad you got him to send a picture. I saw that this AM and was curious. I don't know enough to tell you any thing MILT where R you ? Doug Hudson closet...
hi, take note of the head close up, there is signs of some weld repair around the exhaust pipe stud, I'm sure there are more horrors lurking......... but, it's...
This bike has been on and off sale several times. Mike McGarry probably knows more about this bike than I do. Anybody notice the toolboxes switched around?...
The guys a dealer. He's been trying to sell it for at least 4 years to my knowledge but wants far more than would be realistic to allow all the faults to be...
Hello, anybody get a look at e-bay today? Looks like someone totally stripped down a high-cam and is selling it off piece by piece. What is sad that it's a...
Unfortunately the breakdown of a motor for parts does seem to work out better than selling it whole. Selling it whole demands that the buyer has some knowledge...
I just added up what the e-bay seller was thinking of getting for his 501-xxx motor. His total for starting bids comes to well over $3,000, which is pretty...
Not in small pieces there isn't! But as part of a $15k complete GS/MSDS bike? Mike Feb 9, 2009 12:45:56 AM, parilla@yahoogroups.com wrote: I just added up what...
 I made a set of footpegs for the earlier type Gran Sport or MSDS (1957,1958 tube frame, no stampings) if anyone is interested. See the photo in the JonJ...
Is there a recommended figure for end float on the crank of my 175 with helical gear primary drive? Both bearings are rollers. I was planning on .003 to .005...
I am not sure if understand you question right. Are you talking about a free float at the end of the crank that carries the primary gear? If so ( I think I did...
Update according to the tank cap questions: Meanwhile I found out who the former supplier of these caps is. The caps and the collars (that where welded into...
I've taken apart quite a few hicams (fewer than I've assembled for reasons we are all too aware of ) & all have had roller main bearings on both sides.Helical...
It seems that any complete high-cam starts around $600 and tops out at $1,200 with 250's being prefered over 175/200's. I have not seen a motor go over $2,000...
More or less the same in the UK £ for $. We have very few 250s here - not that 175s are exactly plentiful - so they are rather more desireable for real-world...
thanks everybody... well then THIS http://annunci.tiscali.it/vi/4521029.htm was a very good deal indeed: matchining engine and frame for only 350 euro... ...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
