I just had a Sony CDXGT400 installed by Circuit City for about $220. And It took less than a hour I hool up my Ipod or the XM Radio in the front AUX and it...
My '04 X is due for some new brake pads, which brings up the question; What are some good aftermarket pads that will work for pulling my ATV trailer and won't...
Does anyone know if the front rotors on an 02 Xterra XE are floating or not.. Thanks __________________________________________________ Do You Yahoo!? Tired of...
Hi Jon, Ed here. I have a 2002 xterra. The best thing I did is immediately pull my factory rotors and convert to brembo rotors and pads. Stopping distance was...
Howdy! I'm having an odd problem with my 2000 Xtrerra 4x4. The flashers blink every so often, while driving or parked, the "clicker" sometimes does not lock...
Not aware of floating rotors. Floating calipers, yes. The rotors are bolted to the wheel hub, can't imagine they could be called "floating" in any manner....
Thanks Brent for your response.. I guess I used the wrong words.. By floating I meant not part of the hub.. I remember that rotors were an integrated part of...
Yes, you have to remove the wheel hub and un-bolt the rotor from it to do a traditional rotor resurfacing job. However, many shops (including all Nissan...
Robin, One other note on your rotor scenario, if you are at the point of doing a brake job, take the extra steps to do the wheel bearings as well. While I was...
Thank you much Brent... I think I have all I need... This weekend will be fun... likexterra <no_reply@yahoogroups.com> wrote: Here's a wheel bearing...
Are the rotors easy to take off? I have to replace pads, and I hear some grindage, so I think I'm going to replace the rotors and pads. I have done this on a...
I recently purchased a 2005 Xterra. I just noticed that the oil pressure gauge drops to low when idling. As soon as I start going the gauge goes back to the...
On my 2006 it tends to stay in the middle of the range at speed or idle.....it might be a bad guage or the oil pressure sending unit on the block is going bad....
I remember about 6 weeks after i bought my gently used xterra, i heard what i though was the typical grinding sound. Well, it wasnt what i thought. Whether OEM...
I'm more curious about this than anything else. When I ride around with one window open there is very uncomfortable concussion that affects my ears. If you put...
Thank you for the e-mail, but unfortunately I have already gone through that noise, and I am knowingly grinding my rotors. Silly, I know. CREATIVE SERVICES: ...
... uncomfortable ... I heard a rumor years ago that the Xterra under speed is about as aerodynamic as a cinder block. Some say that it is the wind hitting...
The 1 window down creates an effect similar to an organ pipe. The air inside the X is resonating. I'm a music professor. ... From: "P504" <p504@...> ... ...
Kier, This is not exclusive to the X. Most cars have a point where this happens. In some it may take more than one window. It is just the way the air flows in...
It's because the inside of a car acts as a resonant cavity when a fluid (air in this case) is introduced at a given velocity, angle of attack, etc. Like the...
HAD THE CAR A TOTAL OF 4 DAYS, DID NOTHING BUT PUT MY FOOT ON THE GAS TO DRIVE AND THE ENGINE MADE A LOUD BOOM PARTS DROPPED FROM THE BOTTOM OF THE CAR AND PUT...
Umm.... Hold on!!! You are saying that you went to a dealer, bought a new Xterra (you mentioned nothing about the model), drove off the lot, and parts started...
Hello, I own a 2001 Xterra XE with ~75K miles. A couple of weeks ago I noticed when I leave my lights on an remove the ignition key that the warning chime no...
Hello, Has anyone taken a rotor off the front? I dug in this evening, and cannot figure out how to get it off. I pulled the caliper, then the caliper mount....
Hello, I went back and revisited the wheel bearing packing job and realized this is how you get the rotor off. One question though, if I put a new rotor on,...
