Anyone who might be interested in buying a M151-A1 just take a look at this weblink below.... http://www.mobilku.net/cgi-bin/index.cgi?p=034&id=517&s= Thanks, ...
Hey thanks, I lost contact with who sent that to me. Im not sure but I think part of the bottom was not there, or it was not made for a m151? It was hitting...
can't get my 151a2 started this trip - it sits for 2 months at a time - but up to now - no probelms- its getting gass to carb filter new pump works starts when...
Have any of you guys thought about making the ammo can racks for the M151 etc? "Stu" Southern New Hampshire, USA "Live Free Or Die" Military Vehicle...
Geoff: I'm not yet a wizard on the A2 fuel system, but it sounds like it might be a stuck float or needle valve in the carb. Do you have the set of tech...
After I installed the deep water fording kit I noticed it created such a spot. Place an ammo box (or 2) on the back left fender where the exhaust stack holder...
I haven't tried it yet but I've purchased a cheap way to jump start a 24 volt vehicle on the trail. At $20 for two 12 volt units it seems like a good deal. My...
I have no interest in the fording kit on mine. The exhaust part just makes the pipes rust out faster. Moisture collects in bend at bottom and system never...
Stu... why not just use bungy cords? Or if you want that authentic military flavoring to it, you can probably get some extra long OD webbing straps from weebee...
Hi Ivan, I have one similiar to that at home, I keep it charging in the house then take it on a long trip with the 12 volt vehicles. But taking 2 of them and...
Gary, Jeff Hain-Matson at Front Line MVs has some very nice 1" straps about 6" long at very reasonable prices. They were cheap enough that when I needed...
I recently installed my engine and am trying to get it running well. There is quit a large vibration throughout the body that changes with engine speed. Is...
Gary, it's definitely NOT normal. Like all 4-bangers, some vibration at idle is normal, but they smooth out once they get a bit above idle RPM. That's a ...
... I use a Stowmaster by Roadmaster. Bought the towbar used for $150.00 and another $75.00 or so for misc. mounting parts. I had to make a mounting bracket...
Greetings from Atlanta GA. Does anyone have a vendor source for the STC/ICE-R diagnostic test set for MV's? Has anyone had good or bad experiences with this...
Frank has them for sale. Frank's Surplus RR1 Box 1200 Holden Rd. Osceola, PA 16942 814-258-7788 fsinc@... www.frankssurplus.com Stuart J. Ellis REALTOR...
Hello All, Here is the problem. I recently bought an uncut A1 body with a good powerpack and drive train.The wiring harness was completely destroyed. I...
Do you have power to the gauges? If so, how about the ground for the gauge panel? "Stu" Southern New Hampshire, USA "Live Free Or Die" Military Vehicle...
Hi Stu, Thanks for the quick reply. I took the gauge cluster out to check the ground and found the connector to the battery gauge had come loose. So the...
High voltage coil? Distributor capacitor? "Stu" Southern New Hampshire, USA "Live Free Or Die" Military Vehicle Preservation Assoc. Merrimack Valley Military...
... wrote: So the gauges are ok now. But still no spark. Any ideas? Thanks , Hector >> Hector, If you have checked out all the battery connections and they are...
My '69 A1 idles fine, sputters at low throttle, and runs fine at full throttle. This problem existed *before* I installed a new carburetor and re-built the...
