I have a 1994 Plymouth Sundance that has a 3.0 engine coupled with the A604 transmission. If I let the car sit for a couple of days and start it up I can...
Its been a while, but I finally got around to updating the info on my Dynasty I maintain on cardomain. http://www.cardomain.com/ride/2182743 Let me know what...
Hate to say it, but there is no way at all that this is an electrical problem. You can unplug all the sensors, computers etc from your A604 and still always...
about 1 yr ago,you may remember that i had lost my crank shaft sensor. I fixed sensor,thank's to you all's help. Got power to the b plus pin,replaced the fuse...
Lost crank shaft sensor ,it was set and checked by codes. Only getting power to the b plus pin on coyle pack. Was sent to a shop,there computer scanned no...
Does anybody have any absolute clue on how to move the belt tensioner on a '93 3.3 Dynasty. The specs on this site have been great, but I just can't figure...
I have a 90 3.3 v6 that just shred its serpentine belt. To get to the tensioner i had to loosen the top screw of the alternator and move it towards the...
,, ... it stared to hapen after I wash the engine after a lot of gess work I took it to the dealer they replace the ECM (the computer)and no more problem...
that is awesome!!! my mothers '00 3.3 GC did somewhere in the 11's in the 1/8th, haha, i dunno where her timeslip is but i've had hers at 115mph with no...
I have no idea where the stock speed limiter is, I’m just assuming it may be a problem. Maybe it will be OK. I figure since the 3.8 is there, I may as well...
Which limitor are you hitting, the speed or the rpm? Nothing you can do to get rid of or modify either without going for full custom EFI & DIS- and I assure...
Where can I get some info on piggybacking another PCM? Does anyone make any software and/or some kind of cable that I could use to look at the stock PCM? _____...
What do you mean by "look at the pcm"? If all you want is to see the stuff in the ccd bus (engine temp, fuel level, rpm etc etc) go get a hand held high end...
Hey I had the same problem with a 1992 (I think), anyway I had absolutely no spark, I checked around and researched and found that the cam sensor also controls...
I have a 91 Dynasty LE 3.3/41TE (i think thats what its called), it's the 4spd auto o/d. For some reason, I'll be cruising down the road at usually above 30...
If you are dropping to 8 volts, I suspect your battery is bad or the cables have issues. A good battery should hold about 12 volts when the charging system...
I replaced the alternator, got a good one from the Junkyard, it worked great. drove the car for a day...30 miles south, 30 miles back to my house, then back...
Go here and read through this: HYPERLINK "http://www.allpar.com/fix/trans.html"http://www.allpar.com/fix/trans.html From: mopar33lv6@yahoogroups.com...
32 - EGR Valve - give it a good cleaning 13 - MAP sensor. http://www.allpar.com/fix/codes.html ... Hi! does anybody knows what code 13 and 32 are? thanks...
Appeal for mechanical help; Stock 1999 Chrysler Town & Country minivan 155,000 miles. Bought it wholesale from a used car dealer friend last month who only...
Offhand, I would say it's the ignition switch. I had to replace the one on my 92 Acclaim because of too much draw on the heater fan switch (it had melted some...
In a message dated 9/6/2007 9:03:13 PM Eastern Daylight Time, ... Yes it did. ************************************** Get a sneak peek of the all-new AOL at...
Hello all and thank you ahead of time for all your input to this complex question. When my car is hot and I come to a complete stop she has a delay bump shift...
its called a 2-1 downshift clunk, and it happens on a decel because there is no driven torque applied inside the transaxle. the only wy to really get rid of it...
Neal, thanks for the info. I have a 1990 Imperial with 40,000 miles on it. What should I do next? There are no codes showing. I guess I'm on borrowed time wth...
ahh, a 90.... okay, i know for a fact that if this trans has never been apart before, it has the old style low reverse lip seals. whats going on is when is...
Neal, one more question. Is a complete tranny job indicated to repair the low reverse lip seals. And about how much will it cost me and will it last? Thanks...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
