It seems to me I've seen someone else ask this but I don't recall if there was a resolution tot he problem. My 1990 Imperial has a 3.3L and A604. When the...
When i still had my air box with a K&N, i had cut open the inlet about 50% bigger for more flow, it was louder then my current cone filter set up, BTW anyone...
i'll let ya know, i'm in the middle of a doing the headgaskets on my '94 GC, i got the felpros, of course i did some port work & bowl blending, heads go on...
Ok, ever since my car overheated on the highway, had all the hoses & clamps replaced- I've smelled coolant when I first start the car, usually until it warms...
... smoke ... problem), ... is ... cap ... getting ... of ... loosing ... after ... i had the same problum on my 67'barracuda . but first u need to try another...
I would highly suggest not replacing ANYTHING until you get the TCU codes and CVIs scanned. Post back results for suggestions as to what may be going wrong. ...
Sounds like your shift cable is warped/bent. I find these hard to obtain outside the dealership, but you could probably get one used for sub-$20 at a salvage...
You sound like a TV infomercial. :) Have you actually measured any of the claims by either the manufacturer, or yourself? I have, and there's a couple things...
yep, the cable broke at the crimp on the trans end. Brad Hogg <luxoliner@...> wrote: It seems to me I've seen someone else ask this but I don't recall if...
So does the entire cable from inside the car need changing? Why would it sorta work if it's broken? I'll look into it tomorrow. ... From: Neal Lamp To:...
Actually HP and gas mileage do not always have that relationship.. Think of it this way, if you have a 150hp engine- it takes moving the TB to say, 1/4 open to...
Maybe it being bent has it catching on something and requiring you to fiddle with it at the shifter to get it to move... ... would it ... there ... D and I ......
there is no way you gained 15hp by doing a cone filter, i'd like to see the dynograph mine picked up like 2-3 with the K&N, then about another 1-2 with the...
Tony! Where are those puppies located on the car? Where do you purchase the speed sensors? Chrysler or Auto Zone? Sometimes Cozette ('91 Imperial) accelerates...
Ok, so I got my O2 sensor finally replaced... and low and behold, I'm still getting error 21. Wiring looks ok, might re-wire the whole O2 circuit this week so...
how would i go about swaping in a 3.0 and a manual transaxle into my 3.3 dyansty ? is a 1990 model .and what vehicals should i try to find to get the best...
You would have to rewire the engine compartment and change the radiator at a minimum. As for the manual tranny, you would need to find a 3.0 5 speed car like...
Measured with an accelerometer, guaranteed to within 1hp. WOT for acceleration. And yes, it gave me that much. The number is consistent with multiple...
Flawed logic. You corrected your own statement by noting that you started driving more conservatively...that is why you gained gas milage. If you drove that...
OK, now for the resolution of this problem: First, the car was taken to the dealer for a fresh fill of ATF+4. It's just too messy for me to do at home. After...
Mark. Can this controller be swapped out and "learned" without using the special tool you refer to? I'd like to improve the shifts on my 90 Imperial and...
If this is for a 90 Imperial (which I think is the car you have), you need part number 4796122. Visually, this controller will have fins on it instead of the...
Ok, remeber a month or so back when my car overheated on the highway and I had it towed to a shop where they did the hoses and clamps? Biggest freaking mistake...
It is a shame that such companies are allowed to stay in business. My advice would be to get confirmation of the mistakes from a SAE certified mechanic and...
anyone know where this is located?? I went out and looked under the hood of my 1991 Dynasty, and didn't see what looked like the ballast resistor I was familar...
There is no such thing on a 90 Dynasty. I'd suspect either low fuel pressure or a bad crank sensor (if it is a 3.3 car). Does the car display any trouble...