Well I finally did it. After abt 6/7 years of having the parts clutter the place, I had my exhaust system put on. The OEM exhaust fell off this summer anyway...
You gotta hear the exhaust i made for the GC, i used a Volvo straight thru resonator, I made my own y-pipe, & have dual sidepipes on the sides, i'll take some...
Ran the '94 GC yesterday, best run was a 17.43 @76, not at all bad for 196K on it!!! the short times were inconsistant due to the badly blown motor mounts,...
Hello, This email message is a notification to let you know that a file has been uploaded to the Files area of the mopar33lv6 group. File :...
mopar33lv6@yahoogroup...
Sep 5, 2005 8:12 pm
2665
Just to let everyone know, I just uploaded into the file section of the group, a mp3 file of my new 3" exhaust system @idle. Let me know what you all think! ...
I have a 91 dodge dynasty 3.3 V6 and when i turn my AC on water drips on the passenger side i was wondering if anyone knew where the drain for the condenser is...
You can change the belt tensioner from below, I believe it's a 13mm. Best with a ratchet and a couple different length extensions. Ideally, if someone else is...
Hello, This email message is a notification to let you know that a file has been uploaded to the Files area of the mopar33lv6 group. File : /ac...
mopar33lv6@yahoogroup...
Sep 7, 2005 3:10 pm
2670
Does anyone know if the 2002 and newer manifolds can bolt onto a 1990-2001 lower intake manifold? I uploaded a picture of one to the manifolds folder inside...
Evaporator drain is on the lower firewall, passenger side. Condenser is self draining, since it is located out in the fresh air ahead of the radiator. Real...
I finally stopped putting it off, and ordered the 58mm TB and the matching 1999/2000 3.x upper intake manifold. Since they're the OEM pair- no porting needed...
the newer heads & cam are bigger? i'd like to know so i can get 'em & personally i think the newer intake doesn't perform at the mid to high end like the '94...
As of 1997 (I do not have info for 1998 and newer) the 3.3 has used two different heads and 3 cams. The first cam was used from 1990-1993 (early) and was...
where can i get the 58mm or bigger tb i have the 99 3.8L plymouth grand voyager In mopar33lv6@yahoogroups.com, "evilshelbydodgeimp" ... had ... acceleration ...
I need the help of every AC/AY (Dynasty, 5th Ave, NYer, Imperial) owner on this list. I am trying to get detailed production #s of all the AC/AYs made from ...
Took a road trip to pickup the 58mm TB and matching 1999 upper intake manifold (3.8 T&C). Only one junkyard in the entire area was able to get one... and I had...
Way way back, there were three or four of us discussing problems with our ATC systems in Imperials and 5th Avenues of the 1990-93 variety. My vacuum sources...
Had the same prob. on my 90 IMP. it most likely the Mod Door. Its plastic. and the drive pin the the door is plastic. if the drive pin brakes the door is lose...
Hi, Mark from Sw Arkansas here Just bought a 1991 Dodge Dynasty LE with a 3.3L V-6 its the diamond blue (light blue), with dark blue cloth upholstry and the...
i hit a bad pot hole a while back and i ended up with 2 flats and 2 bad wheels as a result. i looked on ebay but nothing for the grand voyager is there any...
I own a 1991 Dodge Dynasty 3.3l Ok here are my symptoms. First about a few weeks ago I noticed that my heater blower motor stopped working but the fuse was...
Tranny in question is in a 1992 Chrysler New Yorker Salon, 3.3 with 62K miles. I've owned the car two years, bought it with 45K miles (little old lady car)....
TCM code 22 can cause limp mode, and is triggered by the 2/4 pressure switch. Try changing the fluid, filter, and solenoid pack. If it reoccurs then something...
I don't want to kill the tranny with a new solenoid pack (I've seen it happen and it ruins the new pack too, my friend did that). I've got a diagnostic manul...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
