a few years back i went though 9 drive shafts before i found out it was a broken trans mount. i would check that out because that would deffently eat drive...
I have the 3.3 in a 99 Grand Voyager. I love the versatility of the beast but the 'cool' factor is sadly lacking. Last month I ran over a cement block in the...
gowritch <gowritch@...> wrote: I have the 3.3 in a 99 Grand Voyager. I love the versatility of the beast but the 'cool' factor is sadly lacking. Last...
I'm currently working on heavily modifying my 91 Caravan AWD (3.3l). My exhaust setup exists of essentially no cat, stock muffler (in the dumbest place ...
I have noticed that some boards, like the intrepid board has toyed with the idea of throwing the 3.8 crank & rods in a 3.3 to get a 3.5. Has anyone here tried...
I could see where this might make sense in an LH car where there is no 3.8 option since it mounts differently. However, in any other car, I'd just go ahead...
OR simply bore the 3.3 out to 3.8 specs - A forum of engine rebuilders I was reading had suggested that rebuilders should use 3.3 blocks bored to 3.8 standard...
I replaced the timing chain on my Caravan at 107k and did not know about the need for a spacer when I reinstalled the original cam position sensor. The engine...
hello i set gaps at .016 its very close to the thickness of a cereal box cardboard rip the corner off of one about 1/4 inch wide and stick it on the NEW sensor...
You will have to have the spacer to get it to run again. I doubt the sensor is shot just need the spacer. I went through the same thing with the crank sensor...
I looked at a new sensor at CarQuest Auto Supply and it had a spacer already on it. I did not buy it. I removed my sensor and the face is undamaged. I'll...
I happened to drive by the dealership and I paid 3 bucks for their spacer. It is about .032 in thickness or twice the thickness of a cereal box cover. I ...
I ABOUT TO STEP UP TO A 2 1/2 PIPES, IN THE PAST ON A DAYTONA I REAMED TO CAT OUT. WHERE I LIVE THERE IS NO SNIFFER TEST. MY QUESTION IS WHAT EFFECTS WOULD THE...
What year? Pre-OBI2, there is no affect...I run my 1991 AWD Caravan without a cat. Post-OBD2, you may get a code for it, but you can ignore it if there if no...
Of course, with a highflow cat you shouldnt get any measuriable power loss or restriction from the cat unless its clogged up- thus its better just to throw one...
Hello! I'm a new member with two Gen 2 vans, a 92 and 93. The 93 has a blown trans. Anyone out there really an expert on these trannies? It's my understanding...
To bad you didn't post this last week. I have a factory (third party) rebuilt on my floor supposedly with all the mods and updates, never been in a vehicle. I...
okay, im a trans guy. the bolt pattern for the 3.3l 3.8l has never changed after 96 they used a new style top mount on the back of the trans that went over the...
I don't think the bolt pattern has changed, but electronic differences prevent interchanges except within a few year ranges. 93-95 is listed as a direct...
... Upgrades? The factory changed stuff as the A604's design progressed. Just about every year the A604 changed starting in '89... the differences were mostly...
I forgot to ask.... How do you know your tranny is shot? Have you run a CVI test? I know that a A604 can be made to look like its shot if there's something...
You got it almost exactly backwards...technically ALL A604s use two speed sensors (input/output), but pre-94 the speedo/odo were controlled through an...
There are more serious changes besides the speed sensors. Even an early 96 tranny won't interchange with a later 96 tranny because of the differences in the...
i live in an area that has nnow sniffer test. If i ream my cat out what affect wll this have on my computer? i;ve done it before, i am moving to a 2 1/2 in...
If your 3.3 is a preOBID2, the comp wont notice it. But I have to say as a side note- that your state may not snuff test now, but it very well may in the...
thanks for stating that mark the only thing worse than no info is the wrong info. like i said before, ill build you a correct 604 for 700 plus shipping,...
the mileage/trip/directional module just suddenly fried,a little smoke and the tell tale smell of electronics melting(a capacitor and diode)inside the corner...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
