Just like the subject says: I have a Cobb Tuning Cold Air Intake including the aluminum tubing, PRM filter with box, and assorted silicone connectors. It's...
Ok, my clutch on my '00 RS is finally starting to slip (33,700 miles). It's only in the early stages of slipping, so what do you think the chances are of the...
Bryan- I had the same experience.... Fought with the dealer for months... Wrote letters... Talked to District Service Managers... Still have the same bad...
Peschman, Josh
josh.peschman@...
Feb 5, 2002 4:56 pm
2898
OK, Hi there. My name is Phil, and I am new to the group. I do not have much experience with Subaru dealers, but I have never have a clutch replaced under...
The clutch is a wear item like brakes. I don't think SOA will cover it so close to 36K miles. Be careful how much you upgrade the clutch. Think of it as a fuse...
Todd Erickson
terickson@...
Feb 5, 2002 5:23 pm
2900
When I got my clutch done I bit the bullet and went for a copper face. Mmmm. All totalled it probably cost me $600-700 including installation. If you can find...
DON'T put that copper button clutch in your RS! It may be well and fine for Jesse's 2.2 but the 2.5 will use that clutch to eat 2nd gear sometime when you...
I would still give it a shot, maybe someone might feel generous. Side note, Should we set some sort of get together for the group? Like what we did last time...
Nue O Sananikone
Nue.O.Sananikone@...
Feb 5, 2002 7:48 pm
2903
I would concur on the Copper Button clutch. I have the 4 button on my Legacy Turbo and it is loud as hell when you are trying to park or do something else that...
Nue O Sananikone
Nue.O.Sananikone@...
Feb 5, 2002 7:55 pm
2904
Nue brings up a good point which I was going to address later this week. I'm thinking of organizing another fun run for early March. Like last time I had...
looks good to me. From: gsturzl2 <garrett@...> on 02/05/2002 08:56 PM GMT Please respond to mnsubaru@yahoogroups.com To:...
Nue O Sananikone
Nue.O.Sananikone@...
Feb 5, 2002 9:35 pm
2906
the clutch is never covered under waranty unless its a defective clutch. Ie its bad from the start. second follow garret's advice. ( one of the few time I...
Probably what made my 1st gear get really loud on my legacy. Kinda hard to drive with the clutch being off or on. No in between. From: "Norm Johnson"...
Nue O Sananikone
Nue.O.Sananikone@...
Feb 6, 2002 3:45 pm
2908
Hey, I don't feel it necessary to have to rev-match on a synchro gearset as long as I have one. When I go half-dog then having a really strong clutch might be...
... If you think about it, though, dumping the clutch applies a large torque spike to the entire drivetrain, that's probably well over the peak output of the...
Eric Seppanen
eds@...
Feb 6, 2002 6:34 pm
2910
Drivetrain shock loads are the killer. I know of a dual disk clutch under development in AU. It gives great holding power but still allows a slower engagement....
Todd Erickson
terickson@...
Feb 6, 2002 6:43 pm
2911
Yeah, a few of us looking at that transmission were discussing this. The torque specs were for average torque loads such as under WOT when the gear is already...
http://www.smallcar.com/svx/5speed.htm Found this while researching some stuff. It's a place near Seattle that has a conversion built for the SVX to drop a...
We have an 82 Subaru Brat for sale for $1000. This Brat comes with a NEW hood, NEW front fenders, a japanese take out engine with low mileage, NEW front...
nomads4fun
nomads4fun@...
Feb 10, 2002 8:39 pm
2914
I just noticed the E-mail address was not complete. That is nomad4fun at aol.com. Phone is 209-742-6565. Ed & Jane....
nomads4fun
nomads4fun@...
Feb 10, 2002 8:42 pm
2915
I just saw a post on a forum about this, so I know I'm not the only person who's experienced it. The other person has a '97 OBS. Every morning with cooler...
Could it be a lifter that isn't filling with oil until good and warm? My fiancée's Miata sounds like a diesel bus for the first 2-3 seconds, until the...
I just had the oil changed at the dealer last week and it seemed to have gotten worse right after that, if that means anything. ... From: "Britton, Phillip"...
I have the same issue.. Every dealer I taked to said that was normal.. ... From: Bryan Williams [mailto:bryan@...] Sent: Monday, February 11, 2002 1:01...
Peschman, Josh
josh.peschman@...
Feb 11, 2002 7:05 pm
2919
Are these 1st generation 2.5's with short skirt pistons. ... From: Peschman, Josh [mailto:josh.peschman@...] Sent: Monday, February 11, 2002 1:05 PM...
Todd Erickson
terickson@...
Feb 11, 2002 7:16 pm
2920
What does short skirt mean? I don't think I've ever heard that term before. ... From: "Todd Erickson" <terickson@...> To: <mnsubaru@yahoogroups.com>...
I have MY 99 RS ... From: Todd Erickson [mailto:terickson@...] Sent: Monday, February 11, 2002 1:16 PM To: 'mnsubaru@yahoogroups.com' Subject: RE:...
Peschman, Josh
josh.peschman@...
Feb 11, 2002 7:30 pm
2922
... I haven't owned a Subaru long enough to know if this is typical (or even possible), but this sounds like a description of hydraulic lash adjusters not...
Eric Seppanen
eds@...
Feb 11, 2002 7:33 pm
2923
It is the part of the piston below the wrist pin the helps stabilize the piston in the bore. The early 2.5's have a short skirt. 2nd generation 2.5's have a...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
