Unless I'm missing something, to check to see if the transfer case has in fact locked up completely, get the car up in the air with all four wheels off the...
Mateen can do it for you, give him a call anytime at 586-764-1210 ... From: zak To: mi3si@yahoogroups.com Subject: [mi3si] Help please!!! Date: Thu, 01 Feb...
Had a bad last 3 weeks, got 2 driving tickets (4 points) and a nasty parking ticket in Detroit. I guess we all have those weeks were our luck catches up with...
I think its the cops way of telling you to not argue against the 5 mile over infraction and just pay the fine with no points. If I recall correctly, in MI 5...
The date is getting close, so thought I'd post this again. From the response I've gotten so far, sounds like we will have a big group! Almost four years, and...
Hi, There is only one 2G Stealth TT for sale on autotrader.com, and just my luck is that it is yellow ;) I still don't know what the insurance will do with my...
I've not heard of those guys, but that doesn't mean anything in particular. As far as non-interference pistons, I haven't heard of those for our cars, but if...
OK, so the ECS things sounds like a simple fix, especially as the seller already bought a new cap and harness. About a 1G 3S, too bad the yellow paint was just...
I've seen several people on the board talk about rebuilding with non-interference pistons, so I don't doubt that this has them. I don't know what side effects...
So does that mean this engine should be able to run higher boost than 15PSI on pump gas? Would the power output of the engine naturally decrease given the...
Also, what is the cost of an engine rebuild assuming the old engine jumped its timing belt, but no serious damage was done. A rough parts + labor figure would...
Any time you increase the compression area it will decrease CR. Standard logic. They also have no room in other places to offset the increased clearance in...
The stock pistons, as well as the forged aftermarket ones I've seen have cut-outs for the valves too. Do the non-interference pistons just have deeper cuts or...
Performance will suffer some. It will also require more intake air to achieve the same boost pressure. Engine rebuilds cost from as low as $1,500 to as high as...
For just a basic rebuild with stock replacement parts (rings, bearings, gaskets, belts, etc.) plan on around $1,700 for parts (with Rusty's discount) and...
The costs for my rebuild were very similar to what John said. But I went with the Stage 3 heads, and also rebuilt the transfer case, installed 3rd gen lash...
But these are machine shop costs, but then there is still the costs to assemble/install everything back together... so the question for you Jeff W would be if...
... Yes, lower CR would require higher boost to get the same power, or put the other way, the power would decrease at the same boost. Regarding costs, mine...
Hi, While I was looking for a 3S online, I came up with a list of questions to send to any seller I found with a decent car on paper. Some questions only...
Hi again, In anticipation that the insurance will likely offer me less money that our cars go for on the market, I would like have a good idea of what the ...
Hi again, So the seller claims that the compression ratio remained stock according to his paperwork from the shop that rebuilt the engine. Can this be tested...
I have a project involving SQL that is basic enough queries and would take an hour or so to generate a report , I need to hire / contract a SQL programmer. If...
There are no pistons available for the 6g72 that are true non- interference design. The valve relief pockets would be too big which would cause problems with...
Unfortunatley, the 5mph 0-point law is only for interstate-type highways in MI. Any local/residential/city streets hit you with 2 points. Trust me, I go to...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
