Crack was fixed and gasket replaced, however the gasket failed in 2 days AGAIN. Does anyone have any insight as to why this is happening ??? Any sugestions are...
Dear All, I've an '86 Series 1 that I used as daily transport until it became a little too unreliable for daily use about 12 months ago. Plans were to give it...
The Midwest Rotary Rally (MRR) is the premier Midwestern event for rotary-powered auto enthusiasts. We are a rotary-community-based event run by an alliance of...
A parts catalog says pull the engine. The service manual says drop the transmission to get the clutch out. This seems like the easier route vs. pulling the...
Pull the trans. J.T. tim4me_2001 <no_reply@yahoogroups.com> wrote:A parts catalog says pull the engine. The service manual says drop the transmission to get...
ALRIGHT I HAVE A 87 RX IT DIED WHEN I WAS DRIVING IT ONE DAY AND WOULDNT START AFTER THAT I'VE CHANGED THE ECU,AND THE COILS BECAUSE I WAS TOLD THAT COULD BE...
... You can get this part easily enough from most any junkyard. However, be absolutely sure that the dowel pins are intact, and that the part is not deformed...
I am trying to get my son's 1990 RX-7 running properly. He added larger exhaust and added a fresh air system. He was told by someone to replace the secondary...
... You don't need the injectors. Focus on vacuum leaks or a sensor problem. Regards, Rob _________________________________________________________________ MSN...
I did not explain properly in my first letter. My son has an RX-7 1990. and changed to larger Exhaust and added a larger air intake system. This is a non turbo...
... Under this condition, the larger secondaries are irrelevant, which indicates another source for the problem. ... The ECU for this car is designed to run 4...
Hi everyone! Since its summer and hot, I am seeing a "theme" in local car events. We're all enjoying whatever opportunity we can find to stay cool and not be...
Thanks Rob, that is great advise. I do have a friend in Sacramento where I live that has a Mazda Shop and is very good. I will check what you said, install the...
Cool, I hope everyone that can go goes. I can't, but someone go represent those rotaries! I have one myself but can't go. Bummer. oh well. ... Do you Yahoo!? ...
Okay i have an 1987 2nd gen rx7 with the plain jane 13b. When i'm driving it for awhile to let it warm up, i let the rpms drop to normal and shut the car off....
I am not sure, but I was reading about this same situation where the injectors being under pressure were leaking fuel into the intake after the motor was shut...
Fellow club members, I found a 1985, purchased it but found nasty body rot on the undercarriage after I got it home. Im currently shipping in my old 1983 with...
What condition are the seats in. ... From: "Andreas" <drozhenbane@...> To: <mazdarx7club@yahoogroups.com> Sent: Friday, August 20, 2004 12:20 PM Subject:...
Hi Ronnie, I too have two of these in the same condition. I am currantly pulling the engines and trannys them desposing of the carcuses (they are rotted ...
I am needing to know where and what wires go to the gas, glass releases as well as where the lights go. I bought an 84 with the instrument panel and all the...
Eddie, I am not quite sure which diagram you are using, but the wires should be easy to trace. I would reccomend using the following links they contain very...
Ronnie, Unfortunately the seats are not the greatest a few cracks in the vinyl, but the springs and frames are in good shape if your up to a little reupholster...
In 1997 when this all started I submitted my letter so bring back the rx-7 to american shores. I hope you all will take the time to submit a letter as well. To...
Hi Gang, I need input concerning the removal of a 12a engine from a 1985 RX7. I have the engine and tranny out of a car that is rotten through and destined for...
Terry, real easy; just disconnect the harnesses at the firewall, radiator hoses, fuel lines and exhaust. it will be easier if you also remove the radiator from...