Thanks for the heads up, Shawn, Do you have a # or web addy? Jim g4331 <G4331@...> wrote: If you don't mind spending a little money and maybe time, get a...
Ok, Lets say that I find an old Ford Courier or a newer Mazda Truck. Can I simply remove piston engine aned bolt up? I would also like to have a rotary...
I believe so, to a point, and you must use the repu bellhousing and clutch. Up to about '90 maybe. Also Bronco II and Ranger. Just look to see if it uses the...
thx, Jim Bob Mears <bmears9413@...> wrote: Item number: 8060950266 Here ya go. Ebay. wiring diagram 1977 REPU SPONSORED LINKS Mazda part Mazda rotary...
Proubly not. For sure if your talking a rotary truck. The Rotary had smaller gears and hubs (sounds backwards, but it was the rotating mass that had to be...
Very nice, any pictures? Message 1 From: "chango4vida" chango4vida@... Date: Wed May 3, 2006 9:37pm(PDT) Subject: i'm 16 and have a 74' repu well, at...
hola te gusto mi repu... espero ke si tu tienes una ??? de donde eres yo soy de chihuahua mexico es bueno saber ke alguien habla español como yo ps la...
Actually, there is one. I don't know if the motorcycle is fuel injected or carbureated, but Suzuki made one in 1975. There was one on ebay 2 weeks ago. Search...
yah but the RE-5 is no longer made, was a little clunky and not fuel injected. There were a few fuel injected Nortons but .... no longer available as well. BT...
my bad i was just telling him that he ain't the only mexican with a repu, and I put my pictures of my repu. if anybody wants to see them they're under "el...
to follow up on a discussion on wheel lug nuts Ford Couriers use LH and RH lug nuts before 1977. After 1977 then went to all right hand lug nuts. Some...
Just wondering why Mazda designed the lower spindle / shaft for the lower front suspension A arm ... so that the bushings are a press fit on serrations on the...
The rubber bushing flexes, and both sleeves stay put. This is why it is SO important to install them in the correct position, any rotational differences side...
I noticed the bad steering the minute I put on new lower bushings. I didn't know what angle to install them. Does anyone have the spec? Is it the angle the arm...
Rule of thumb- Find the angle at which the a-arm would occupy while the car is at rest, on the ground. record precisely, by measurement. Then install the...
There is no procedure in any of the Ford or Mazda manuals for replacing these damn bushings. Ridiculous. I don't like the way it was set up and I don't...
Most old american cars had serrated bushing sleeves- that's where mazda got the idea. The rubber is supposed to flex, it's what rubber does, and this design...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
