Try Direct Line for the insurance. They're fairly competative, plus they know all about the RSK, as opposed to most other insurance companies which have never...
adam_honeyball@...
May 1, 2001 9:49 pm
2084
Hi there. I'm hoping you can help me with a problem I'm having. I have a twinturbo Subaru Legacy (95) and the engine check lamp is active. I've taken it to...
Re-chan
re-chan@...
May 3, 2001 5:01 am
2085
where in Aus are you? ... From: Re-chan [mailto:re-chan@...] Sent: Thursday, 3 May 2001 12:27 To: legacyb4@yahoogroups.com Subject: [B4] Legacy RS...
Scott, Ian - Sydney
scott.ian@...
May 5, 2001 11:30 am
2086
Finally got to take my B4 out for a drive tonite after spending the last 3 days behind the wheel of a very, very hot Blitzen in GT3... Things I noticed: - my...
Jeff Tsai
jeffreytsai@...
May 5, 2001 2:47 pm
2087
Scott / Ben, Read abt the intelligent intercooler water-spray system from Autospeed. http://www.autospeed.com/cgi-bin/browse.cgi?category=288 ...
C K Lim
kanglck1@...
May 5, 2001 6:29 pm
2088
... Well, I have no idea about the error codes - is there anything wrong with the running? My bet would be on a faulty air flow sensor, those are notoriously...
Paul Hansen
p-hansen@...
May 7, 2001 12:48 am
2089
Well it's hard to say yet. The engine itself starts and runs fine while free revving. But as yet we haven't had the chance to actually drive the car yet, so I...
Re-chan
re-chan@...
May 7, 2001 5:33 am
2090
Does anyone know if it possible to put a WRX turbo/intercoller unit onto an EJ25 engine? i.e. can you simply tke the turbo off an ej20 and plonk it onto the...
Danny Chan
chingchi@...
May 7, 2001 5:56 am
2091
Not sure exactly. We know it's a hydraulic 'pull' type clutch system. Naturally, it's not compatible with the original clutch setup in the car (like almost...
Re-chan
re-chan@...
May 7, 2001 6:51 am
2092
hehe easy :) We're doing a whole engine swap, gearbox, diffs, suspension, ECU, the works. I can even begin to list all the extra parts we thought would be the...
Re-chan
re-chan@...
May 7, 2001 9:48 am
2093
Can anyone help out here?...
Jeff Tsai
jeffreytsai@...
May 7, 2001 1:24 pm
2094
plenty.........to start with, engine compression.... ... From: Danny Chan To: Legacyb4@Yahoogroups. Com Sent: Monday, May 07, 2001 4:00 PM Subject: [B4] EJ25...
Rod
melrod@...
May 7, 2001 2:45 pm
2095
Anybody heard if Subaru have released a revised AFS for the B4 etc.I have just had mine replaced but was told there was a revision available but may be a while...
avo@...
May 7, 2001 7:26 pm
2096
the compression is different for one thing, this could cause problems of detonation etc. also the motor is not that strong apparently when it is blown ... ...
Scott, Ian - Sydney
scott.ian@...
May 8, 2001 9:00 am
2097
B&L Kaeding, how much is this costing you? I have thought of doing this many times, why did you start with a 2wd GX? I was looking at doing it to a 98 RX...
Scott, Ian - Sydney
scott.ian@...
May 8, 2001 9:24 am
2098
The reason I was asking is that a friend of mine has a NA Integra and sent it to the shops to have a 200SX turbo unit bolted on. I thought that it would be a...
Danny Chan
chingchi@...
May 8, 2001 9:47 am
2099
... Honda's have become popular in the states for turbo bolt-ons, mainly because of a lack of....vigor, shall we say, normally. They are fairly robust for...
Paul Hansen
p-hansen@...
May 9, 2001 1:00 am
2100
Hi everyone. Thanks to all those who helped me out with this. The 'differential pressure' fault code turned out to simply be some guk blocking one of the...
Re-chan
re-chan@...
May 14, 2001 7:32 am
2101
The job is costing around 10k (AU$) The halfcut cost me $5500, including all the awd drivetrain and RS suspension. Labour is around 3k, and misc extra parts...
Re-chan
re-chan@...
May 14, 2001 8:01 am
2102
... Nope, won't work - major internal differences between the engines, at least, major enough to make the ECU not work. Turbo's were different, some other...
Paul Hansen
p-hansen@...
May 14, 2001 8:29 am
2103
Hi there. Can anyone enlighten me on what the B4 uses for its primary and secondary turbos? Thanks! chin min...
juncl@...
May 14, 2001 2:47 pm
2104
Which pinouts are you after Greg ?? The actual ECU connectors going out of /into the ECU ? Chip pinouts ? Subaru Connector pinouts from under dash diagnostic...
Paul Julian
reliance_systems@...
May 16, 2001 11:49 pm
2105
Guys, I am replacing the exhaust on my 96 GT and would like any suggestions you may have. I am thinking of replacing the section from the second CAT back with...
Paul Julian
reliance_systems@...
May 17, 2001 12:01 am
2106
... The ECU is what controls boost - somehow. It's a self-adjusting ECU also, and it may have detected a bad load of gas. If so, it takes a while to recover...
Paul Hansen
p-hansen@...
May 17, 2001 1:31 am
2107
Thanks Paul. I'm doing the boost test in 3rd. Basically at the moment I am getting about 0.7 bar and 1 bar is about 14.3 psi I think. Maybe I should look at an...
Paul Julian
reliance_systems@...
May 17, 2001 1:45 am
2108
... I'm not that much of an expert, but it does sound like you've got a boost loss problem somewhere. We actually get max boost in 4th, more than third, but...
Paul Hansen
p-hansen@...
May 17, 2001 1:57 am
2109
As far as I know the A/F meter is OK, but I should probably find another one to try, maybe the one off my RS might fit, have to check the part numbers. Your...
Paul Julian
reliance_systems@...
May 17, 2001 2:02 am
2110
Hmmm, which model ? I could have a look at my old turbos at home and let you know, but they are off a 96 GT, would that help ? Regards Paul ... From:...
Paul Julian
reliance_systems@...
May 17, 2001 2:03 am
2111
Lorren, I have a instrument cluster off a jap spec 96 GT, will that help ? It only has the 180 km/h speedo of course. Regards Paul ... From: Re-chan...
Paul Julian
reliance_systems@...
May 17, 2001 2:04 am
2112
For the most part, cat-back mufflers and sportier air filters... Peter has a Prova ECU with a HKS Hypermuffler but he hasn't put his car on the dyno yet. I've...
