Got a .100 oriface at the boost source, followed by a tee and the neele valve for the bleed. Then from there it is .25" OD steel tube all the way to the...
Hello peeps out there. So i have fell in love with the turbo idea and i have done my research found my products the ONLY thing i cant figure out is the tuning....
Try theturboforums.com
a wealth of tuning and combo info over there. It was formerly turbomustangs.com so it is mostly geared at what you are looking at....
Depending on the sizes and wall-thickness needed - Summit sells mandrel bends in most exhaust sizes. They are thin wall and available in stainless and mild...
Heartthrob sells through JC Whitney. The prices are good, and the quality of the bends is very high. My turbo bike's exhaust is all Heartthrob bends. If you...
There's an idea! Aluminum headers. Think of the weight savings! From: jyturbo@yahoogroups.com [mailto:jyturbo@yahoogroups.com] On Behalf Of gfedcba12345 ...
Actually headers can be made from aluminum. Well, more specifically, the exhauust manifold. Had a car show here and there was a big old Ford Big block with a...
Now that you mention it, I do remember aluminum exhaust manifolds. I was trying to be silly. But if you were to mount a turbo, especially close to the...
Joe, there would certainly be a problem on my race motor! My EGT right before the turbo inlet flange is just at 1600 deg at full boogie. NA might be ok, but...
... I was the SD 421 Ponchos from '62 that had cast Al shorty header exhaust manifolds. For the drag cars, ONLY. Even NA, they tended to drip bits of Al by the...
... Nah, that would work perfectly. Just use really thick aluminum tubing, and run the engine at full chat for about an hour. Any aluminum that sticks out...
Boats run aluminum manifolds and turbos. The key is the water cooling and thick enough aluminum. A correct afr (neither too rich nor too lean) is key as well....
This reminds me of when I installed a straight-pipe exhaust on my Briggs & Stratton 5 HP go cart. I used 3/4 aluminum pipe. It melted off about 2 inches from...
Something else along these lines, when I was researching header coatings I found a post somewhere talking about the NASCAR guys. They found that steel headers...
Since WOS I have been hard at it. Nearly 6 weeks or so. What have I accomplished. Some might see it as just a little bit, but not me! I had the leaky fuel...
That's where the turbo air enters the throttle body. I tried to find something commercial to do the job and all the ones I found were for carbs with a 5 1/8...
From: jyturbo@yahoogroups.com drmayf Sent: Sunday, November 01, 2009 8:58 AM That's where the turbo air enters the throttle body. I tried to find something...
here is a link for Columbia river bending http://www.mandrelbends.com/ they are a sponsor on HomemadeTurbo - DIY Turbo Forum Classifieds HMT Sponsors...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
