Nope. The inline 6 (4.0L) uses a different bellhousing and stronger trans than the 4 cyl and 2.8 V6 rigs. If you have the 2.8 V6, a Chev S10 or Camaro 2.8, 3.1...
No, and that's what sucks. It would have been nice if they would have kept the same bolt pattern over the years and for the 4, V6, inline 6 to all bolt to any...
It's not as bad as you may think. If they were all interchangeable, he'd have bolted it up to that AX-5 and promptly blown the trans to bits. :-( --Pete...
I just found and purchased 2 Comanches that have been sitting 4 a few years.....88 i6 2wd and 89 i6 4X4, both standards......for $700....I cant wait to pick...
The nice thing is you can upgrade the 4 cyl to an AX-15 with a bellhousing and clutch from a Dakota with 2.5L. Re: i6 to comanche tranny Posted by: "Peter...
There is a Jeep Rally on May 7 - 10, 2009 in Eureka Springs, Arkansas. Jeep Weekend Rally Information - www.jeepweekend.com Eureka Springs, Arkansas...
Can't get much purdyer than that place. Beautiful area. Wish I could go but too much work for me right now. But defiantly one of my favorite places to go....
hey all, i have an 88 2wd with a 2.5 and a 4spd, and i want to swap in a five speed.... my question is, how different is an ax5 from a 2wheel drive than a...
A 2wd AX-5 will have a long tail cone in place of the T-case on the 4x4. I believe that the driveshaft is also shorter.You can get more help over at...
Too bad you're not close to Seattle. I have an AX5 I pulled to do a 4x4 swap for only $50. It was from my '86 I bought back in '99 (I currently own it again...
Theres good days at the boneyards and theres bad days. Today SUCKED!! Didnt get anything I went for but... I did come home with a set of front coils off a ZJ...
ZJ coils should give you approximately 1" of lift over the MJ. A ZJ pitman arm will give you approximately 1" of drop, more like 3/4" of drop, over the MJ. And...
Hey all... This is my first post on the forum. So naturally I have a dumb question. Two actually. First, my MJ is an '85 prototype, but basically an '86 with a...
You get wander on the highway (steering follows the road ruts) question about swaybar links Posted by: "bighigaz" bighigaz@... bighigaz Date: Wed Apr 8,...
That's what I figured... But I don't do a lot of highway. How will it effect offroad/dirt roads, fast and slow? Sent from my Verizon Wireless BlackBerry ... ...
You shouldn't notice that much difference whether they're hooked up or not. I don't. The only place I notice any difference at all is going around curves and...
Cool! I do have aZJ pitman I forgot about n will toss it on also. Didnt know about the steering jazz so since there were about 6 of them there I will return...
I have a 91 Cherokee larado fs. I6 power buckets pw, automatic. The engine needs a new S/belt. I started it up after 6-8 months sitting and it started right...
alternators are really bad about locking up on the I-6's if they're left sitting for very long. I've had 4 do the same thing. *********** REPLY SEPARATOR...
I'm reposting this Laredo. It has power seats (cloth) and PW & PL a I 6 automatic 4x4 I need it out of here. Glass all around is good. I could take the time...
I have been relying on my 1994 Comanche 4x4 for daily transportation to and from work. My regular car has a problem that maybe you guys can help me with. I...
Did you check to make sure the bulb is not burnt out? Easy to miss the simple things sometimes. Chuck When life brings you storms, learn to dance in the...
is there anyplace to find front lowering springs for a comanche? Mine is 2wd and i dont want to go through the hassle of making it 4wd. And i have a broken...
I don't know of any after market lowering spring kit for our beloved trucks.. Put a pair of used springs in because they already have some of the spunk knocked...
Stock TJ springs will lower it an inch or so. A quick search at comancheclub.com/forums should bring up the thread where it was mentioned. :-) --Pete...