the commanche i found is a 1988 6 cylinder with four wheel drive. it has a little rust on the right rear quarter pannel and some covered up under the driver...
Phil, I completely forgot to give you a call. My wife had surgery last week and my mind has been elsewhere. I will try to give you a call today. Sorry about...
I'd lean more toward the plenum in the heater/evap box as the problem. Everything else mechanical on your AC system checks out good. The expansion valve on a...
Anyone ever heard of an "X" model MJ? I came across one in the 'yard Saturday. Nothing special about it really....it's an 86, 2WD, 2.8L, auto on the column....
'X' was a trim designation. More stuff than the base mosel, less than the XLS. The trim level apparently didn't mean a whole lot in 1986 cause my 86 is a...
I switch over my cluster from the idoit light to mechanical gauge's. I did this because i didnt like looking at a temp gauge after my 4.0 got hot! So this...
Guess it didn't take much to sell something back in the day, huh? LOL (And I thought my Sporttruck MJ was a base model...) I dug through the muck and mud in...
Another goodie I picked up this weekend was a set of factory tow hooks/brackets off an 89 XJ for someone who needs them. But this set has some sort of...
When you change from idiot lights to gages you have to change the sending units as well. Change the oil pressure sending unit and the temp sending unit and ...
Hello I did change over the temp sending unit and the oil pressure switch! They are both for mechanical gauge's the temp works the oil dosn't work the needle...
I was referring to the DS u-joints & all 3 are good. The steering joints on the axle shafts are new - besides, pulling the front DS would not affect those at...
How are the pinion bearings at the axle? Any slop? Any slop at the t-case end? I assume you checked them but it doesn't hurt to ask. I was thinking that...
I bought a new flywheel and she fired right up. Thanks again! Now on to the new questions. 1. What will cause the speedo to not work? Where do I start? 2. What...
If I remember right, the H.O. era switched positive and negative with the way the fuel float reads the gas level. The 88 t-case has a mechanical connection to...
hello i am thinking of removing the doors off my comanche. contacting dmv to see if legal, but hoping may be someone has pics of theirs removed? thanks alot....
Hey Jeff --- no pics needed I'll take em. let me know if you need shipping address again. thanks Kevin ... set ... that ... part ... been ... nice ... it ... ...
A: Sounds to me like the heater is still on with the AC! Check the hot water valve under the hood is closing (but not totally or it will freeze up inside...
A: There is one here in Seattle for $150. (make sure that is a Jeep and not Ford or Chev NP208!) From: "uplandhawaii" <uplandhawaii@...> Subject: Re:...
A: The screw in sensor on the motor by the oil filter needs changing for the gauge to read. From: "lenny47us" <greenmtnman@...> Subject: oil pressure...
Hi Jim I changed all the what needed to be changed! I'm stuck and thinking about just putting on a old fashion oil gauge with the line to the gauge that is...
Hey- awhile back someone was looking for a set of the "turbine" style older alloys. Well, I picked up a 93 XJ (free) and someone had slapped these on. Anyone...
A: Probably the tcase front output bearing or front axle pinion bearing (should be pretty easy to tell now with the shaft out) What setup? I'm getting rid of...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
