My girlfriend says that the pillion seat is too uncomfortable for anything more than a few miles, so I was thinking about getting a different seat. Does...
Hi Scott , The jackal rear seat is a very bad design and unfortunatly no other seat will fit and as far as I know no aftermarket seat fits either . I run a...
Scott – I mounted a Stone Touring seat on my ’00 Jackal for that very reason, but according to my lady, the improvement is negligible. It was a simple...
... My child bride also hated the pillion, she called it a suppository. Had it rebuilt at the same time I had the saddle rebuilt by Bill Mayer Saddles and she...
Thought I should mention it here before putting it up on eBay. I bought a Corbin saddle for my Stone a year and a half ago but I like taking dates on rides too...
Hey Steve I just started looking into haveing a corbin saddle made for my stone. I wanted to have it made so I sit a bit lower to the ground. Is there a height...
I have a Corbin on my Jackal. It sits lower than the stock seat. I still have the stock pillion on it too, for when the FMMG rides Bioch. Motogeezer ... stone....
Hey Steve Where are you located? I am in San Francisco. Tony ... From: Steven Scotten To: jackalownersclub@yahoogroups.com Sent: Sunday, June 24, 2007 2:16 PM ...
Me too. I live in Dogpatch. Always nice to encounter another SF Guzzi rider! I saw a lovely woman riding a V7 down South Van Ness yesterday and nearly died...
Hey Steve Can I stop by sometime and look at the saddle and see how it fits. Tony ... From: Steven Scotten To: jackalownersclub@yahoogroups.com Sent: Sunday,...
Hello All, Summer is here and I've finally changed the oils in the engine (including the differential and shaft oil...not the fork yet) to Motul synthetic. As...
I have an '01 Stone (w/EZS sidecar) that has an M-G windscreen which is too verticle, too small, and too far from my riding position. My Shoei helmet is very...
There is a second transmission drain plug, centre rear of the gearbox. The tail light assembly (assuming you have the twin lights, with the indicators attached...
I use the Plexifaring III, not the most aesthetic thing in the world, but works excellent. It's easy to get on and off. I use it when I'm on trips. MotoGeezer...
... Early in the life of my Jackal I replaced that colostomy bag behind the transmission with an H-pipe. Makes getting to the trans. drain plug as simple as...
... A couple of years ago I bought a Clearview shield for the Jackal. I needed better coverage, and like you, wasn't satisfied with the Classic windshield....
Me too. As a bonus, the exhaust note improves, even with stock mufflers in place. Jay +++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++ ...
... Not sure about Jay's experience, but I didn't do anything to efi after install. That was about 70000 miles ago, and still haven't done anything other than...
I installed a Power Commander on my Jackal before I installed the h-pipe, and recommend it to anyone, whether they go to the H-pipe or not. Even the stock...
Actually, I just recently tried to buy this assembly. I purchased my jackal a few weeks ago and quickly noticed the indicator lights were close to dangling,...
If you can manage to fabricate something, especially if it holds the indicators better, make a few, you will sell them easy. patrick ... From: Stephen...
Hi Jack. When I bought my '00 Jackal last year it had a windscreen mounted. I was told that it was an EV screen. It is large, covers extremely well and...
... ******************************************************************* Since I hated the look of that whole setup in the rear, I mounted a replica of the...
Hi All. I own a Y2K Jackal. Keep in mind that I am old, senile and frugal(cheap). I did the TPS set thing. Remove the linkage, Backout all the screw adjusters,...
I used the same replica Lucas taillight on my first Jackal, w/ some universal bullet style turnsignals mounted to the fenders. Really cleaned up the rear and...
Jay, is this the picture of the Lucas Tail light? I would love to figure out a replacement for mine http://www.vtwinmfg.com/catalogs/cyr/pdf/TAILLIGHT.pdf ...