The problem usually starts when the engine is a operating temp. It is fuel injected. Manuel trans. Yes it restarts immediately. It happens when it is...
I finally found a hardtop for my 99 Amigo. It came from a junk yard and I ordered it "complete" meaning all parts to install, including hardware. Well it came...
Chcek the vacuum that the enginge is producing by hooking up a gage to the intake manifold. The reading at idle should be above 15" of vacuum. The needle ...
Thank you so uch for your help. I will try it and let you know. Again thanks. Bob Cornett <socaldood@...> wrote: Chcek the vacuum that the enginge is...
I have a brand new factory Spare tire cover that fits 235/75-15 spare for sale if anyone is interested. Let me know and we can send pics and so forth. Since my...
Hi everyone, I have a 98 amigo 3.2l 5 speed w/85,000 on it. Of late it has been stalling when the engine drops to idle after it has warmed up. The idle rpm has...
It has been my experience that when the idle jumps around and goes high (1100) rpm the intake plenum gaskets are leaking. That is the most common vacuum leak...
Thanks. Is there any simple test to verify? On my older cars I would run an unlit propane torch around the carb to find vacuum leaks. Would this work in ...
I just thought that i would give everyone a laugh, and then maybe see if there is another place to go and look. I call the Isuzu joint to get a shade to go on...
my fathers family are all from the New Orleans area.... my family are all in oklahoma now... cool, another isuzu schroeder... i am trying to get my 92 Amigo...
My wife has a 94 4x4 2.6 that she can't kill! Rust is going to get it first I think. I was lucky to get a 99 with 36,000, 4x4, 2.2 for $6g, killer deal, time...
i wanted a 4x4, but i couldn't pass this deal up either, i needed a vehicle for her when she turned 16 and we worked on it and got it looking too cool i guess...
... and ... back ... that cool ... back on is a ... takes 5 minutes. ... burnt ... on tv with the ... have drive ... k..It's 2006 now and i am officially late....
You need to find where the water is going. Fill it up, includung the overflow. Drive it till totally warmed up, then look for the leak. You should at least...
Thanks. I'll give it a shot. ... __________________________________________________ Do You Yahoo!? Tired of spam? Yahoo! Mail has the best spam protection...
Hello, I'm new to the group and own a 1990 Trooper that I plan to rebuild the engine in. Does anyone here know if the factory stock connecting rods are cast or...
Just to thank you - That did the trick, it starts right up! Who would have known that a fuel filter would cause that! I could blow air through it but it seemed...
Ok so thanks to Carlos Zayas I got the hard starting fixed with a fuel filter - here is another thing that has been happening that I would like to run by the...
... k...i took it over to my dad and we both looked at it...it's not the radiator..it's probably the water pump or one of the lines leading to it..since it's...
Water pump, a pain in the butt. It is a cheap part, very cheap compared to a complete overall ask me.... If it is the water pump then there is a few things you...
... Hi, no I'm referring to the piston connecting rods for the 2.6 litre 4 cylinder engine. I'm wanting to know if the factory units are cast iron or forged?...
I would hope that they are forged. From air-cooled VW experience, cast parts do not have the strength of forged parts. Cast parts are usually better in parts...
My Amigo was running rough and in order to make it drivable at all I had to advance the timing or it would not run. I have been chasing this problem since I...
I had a similar problem that ended up that the distributer was bad. when it got hot the unit that takes the place of the old points would start to act up. I...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
