I didn't see any other husqvarna motorcycle clubs on yahoo, so i thought i'd create my own. Anyway, I've got an '83 xc175 husky, that i could use parts, advice...
Hi Moto Man, glad to see a Husky club here on Yahoo. I recently inherited an '87 430 CR from a buddy who had too many responsibilities. Can't beat free, so now...
I hope its ok I posted photo of my 1999 TE410. The only stuff I have found on net for huskys is from www.husqvarnausa.com<br>Anybody know of any message...
There's a pretty good site called Huskyclub.com. When I picked up my 430, the guy didn't even know what year bike it was. That site gave me the info I needed ...
Yaa, i'm a little sad, just traded my husky last weekend for an '85 Honda 350x 3-wheeler. I had an '83 husqvarna xc175. It was a great bike only problem was ...
my bike had a screw that came out by the crankcase, and you filled it with oil until it came out of where the screw went in, thats about all i know about that....
Hi, Well i came across an '84 xc500 bike for parts i was thinking about getting. Would anyone be interested in any parts from it, i guess its the last dual...
Most of Huskys made in the 90s have 3 round roller chain guides. Each roller was two ball bearings that rusted and woreout or seized after one year. They cost...
I never had to change the swing arm bearings because after 1990 they had grease fittings and the shock link has fittings too on the bottom. I also drilled a ...
I was going to go buy that xc500 in seattle, but it was sold when i called on it again. Too bad because those parts (ohlins dual rear air shocks) are getting...
Hey guys, I am looking for a husky to race next summer. My father is racing the AHRMA hare scramble series. I was wanting to run a few races w/ him. We are ...
mine is an '81, its fast when started, but is hard to get started. It also backfires very bad!! Its for sale $500, but georgia is a bit far from Oregon. ride...
I have a 1972 250. Eng# 2018 1763, Frame# MJ04541 in pristine condition. All paint excellant except for two 1" circles on top of tank(gas burn). I'm third...
Lets start at $1800.00. If your serious, contact me at my previous E-mail address. I'll give you a complete rundown on the bike and we'll dicker from there. ...
Alright guys, here's the problem. I have to change the bearings in my rear wheel and swingarm. I have everything off of the swing arm now and the bolt ...
i had the same problem with my rear tire axle. I used a bunch of penetrating oil, then used a pointed hardened steel chisel and hit is in the center of the...
Not sure if you already got an answer for this, but check this link for some dealers which can help. I've used Halls a few times and they seem to know their...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
