... etc., based on YOUR recent experiences. You can also take a look at other member's experiences with these and other items. Also take a look at the Database...
hondareflexowners@yah...
Jun 1, 2009 10:40 am
56968
MONTHLY WELL-INTENTIONED REMINDER Fuel System: Keep the fuel tank full - especially during prolonged storage - to avoid rust. Exhaust System: Check all of the...
hondareflexowners@yah...
Jun 1, 2009 10:40 am
56969
Thanks, Lisa! My husband is having some real problems with his back, I'm hoping something like this will help. It's really neat that they custom make the...
Are you sure that you were pulling the left brake handle ALL the way in, and that the engine cutoff switch was set to run, and that the side stand was ...
What I ended up doing was rewiring it. Since power was getting to the headlight relay, I went from the low beam output leg on that, to the low beam. I ran my...
... I found that the round blank in the middle of the glove box exactly fits a cigarette lighter socket. Made for it. My hands were too big to work underneath...
I ASS U ME you have already checked the headlight fuse (you probably stated that in an earlier post). It is the "headlight Relay" - called the "Main Relay" -...
Does it "click"? Does it Whirr? Do the headlights go out when you press the starter switch? Will the horn honk normally? (a good "rough" battery check) Is the...
I suspect, as you said, the problem is up in the handlebars. I had to have lights this morning, it was getting on in the afternoon yesterday, so I rewired the...
I'm not sure what the original problem is here but if your headlights aren't coming on I would suggest what Bruce suggested to see if it's the starter. I...
It was the actual stater itself, or the starter button? Thank you for your reply, I'm notating everyone's suggestions so that I can eventually get it back to...
Inside where the starter button is. We took the 'top' off, sprayed inside with WD-40, hit the starter a few times to loosen up the spray, turned the ignition...
Awesome, that's what Bruce said too. We had almost 2 1/2 weeks of solid rain, although I kept the bike covered, but I bet that's what happened. I really...
... Do you realize that if the light switch is set to the high beams, both lights are on simultaneously? This is the way many of us run all the time. ... Is...
... Yes, I used to run high usually. I just mentioned, that during my temporary wiring job, that I wired both to run. ... No damage to any of then wires or...
Tim, in answer to your questions: Are you sure that you were pulling the left brake handle ALL the way in, and that the engine cutoff switch was set to run,...
Hi All, I hate to divert this thread, but it reminded me that a little whil back, there was a discussion about reconfiguring the headlights wiring so that (if...
Why would you want to change the wiring when you have it on high both lights burn and when its on low only the low light burns I think its only the way the...
Well, recently, I was forced to do something quick and I wired mine up so both run simultaneously. I always ran it on 'hi' when riding anyway, so I'm not too...
... You need metric screws of the correct diameter, length, and thread pitch. The problem is that there is no pre-defined "set" of spare screws - so you would...
... It is fairly common to re-use paper filters. Typically people "slam" then on a cement surface and much of the accumulated dirt will fall out. You can also...
My question is - what is the point? The US Reflex has two identical single filament H7 automotive bulbs - one in each reflector. If you want them BOTH on, all...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
