It's not an 1157 (which is the old brass base bulb), it is a 3157 (same electically, but flattened "square edge" type-base. Of course that doesn't change your...
Sept 2007 Two members have recently experienced a catastrophic engine failure due to oil loss!!!! NEITHER observed tailpipe smoke or seepage or a puddle of...
hondareflexowners@yah...
Oct 1, 2007 11:37 am
47513
All, I just replaced my current single headlight modulator with a duel modulator. That leaves me with the old one from comagination.com that I would like to...
The Gerbing gloves come with the harness, wires from gloves to the harness and of course the gloves. Because I will be keeping both the Mp3 and the Reflex I...
The only towns I can think of like that would be either Raleigh, Chapel Hill, or High Point. We actually drove up to Falls Church, VA for a concert and then...
I'm going to install one of those new fangled Back Off! LED license plate frames on my wife's 2005 Reflex. Anyone else done it? I pulled the Reflex Lighting...
Bill, I got to everything I needed to by only removing the snap-in plastic section located in the rear of the under seat storage area. I don't think you need ...
That's why you gotta love this rider's forum, instant answers and good tips! You no doubt saved me a fair amount of time and possible grief. Many thanks. BTW,...
If you are only adding the license frame with the LED running/stop lights then that is correct ... ... but if you are installing a "back-off" taillight...
GeoB: I dissembled mine ( the left brake assembley) so I could bend the switch acuator to get it just where I wanted it. Not loose & not to tight with the ...
Again Dennis, my thanks for the speedy and complete answer. I'm not installing the tail light flasher, just the frame LEDs so I'll just be tapping one side....
Do many of you ride two-up regularly? I took my wife out today for her first ride and realized we exceded the 300 lb weight limit. I am over 200 lbs alone....
Hi Deb, Great to hear from you again. How did/do you know your scoot will handle all that electrical equipment? How does one find out that info? Susan- ...
Ah, thanks for the memory jog. I believe it’s Raleigh. Susan_NJ _____ From: hondareflexowners@yahoogroups.com [mailto:hondareflexowners@yahoogroups.com]...
License plate is operational (thanks to Dennis' advice) and life is good. Bill Lozon ... plate frame ... and good ... grief. ... need to ... LEDs ... plastic ...
All of the solid (not stripped) green wires are ground. Bruce PS - a good way to tap into wires (which undoubtedly some purists will rightfully argue risks...
Look in the Polls section for some feedback on this. You are right - it is harder on the scooter, but the scooter is built to handle it. It's just like...
The very designs of many LEDs tend to focus their light within a narrow angle - due to a small lens incorporated into their tips - and this will make them...
If you live in Southern California (Ventura, Los Angeles, Orange, San Diego, San Bernandino, Riverside, Kern Counties) and have NOT signed up yet, take a ...
OK guys, thanks. Sue _____ From: hondareflexowners@yahoogroups.com [mailto:hondareflexowners@yahoogroups.com] On Behalf Of Pat Barrett Sent: Monday, October...
... Recently I have been seeing another type, one that doesn't always have a lens over it. They look like lil surface-mount chips. They are lots brighter than...
Yesterday I came as close to laying down my scoot as I ever care to admit. I'm not a newbie and there was nothing about the time or location that were...
I did almost the same thing a few weeks ago.... Don and I rode our bikes up to a restaurant in Raleigh and as we were parking our bikes I decided to move Kitty...
We rode two up for over a year, and together we were close to 400 lbs. I worried the whole time, but once we did the mountains I decided we needed a bigger...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
