The fact is that it is around 100K makes me think it is a "warning" to bring the car in for "inspection". Translation? Spend money, sometimes a lot of money....
Hi Folks this is August and I have a 2001 with the 2 liter engine. I have the following problem that I have never seen mentioned over the years here with this...
I had a similar problem with mine about 6 years ago. The Honda Dealer I saw fixed it and I haven't had a problem since. I have no idea what they did. I was...
You could bend out the tapered end slightly so it fits tighter or pull it out clean it off with solvent then put some JB Weld on it. 73 Bob w9eta To:...
AN OPEN EMAIL TO ANY PERSON WANTING TO JOIN THIS HONDA CRV GROUP. WITH YOUR APPLICATION I MUST ALSO HAVE YOU INCLUDE YOUR EMAIL ADDRESS. I HAVE AT LEAST ONE...
Bob and others answering my request for help. I just called my"FRIENDLY HONDA DEALER" Ha-Ha . . . And they said they could repair it by cleaning it up and...
Honda Bond is a grey adhesive similar to Permatex form a gasket.It is a silicone product that is oil resistant. Sid [Non-text portions of this message have...
Thanks Sid, In fact the service mgr. mentioned they used it for head gaskets and I wondered at that time if it was like Permatex that is a great sealant if in...
I have used it for years on motorcycles to seal transmission cases and valve cover gaskets to name a few. Yamaha makes a similar product called Yamabond. Good...
Thanks, Before I buy I have the following questions please guy's. Is a "Permabond, Hondabond, Yamabond a better choice than JB Weld???? Will any of the...
I am new to this group and have a situation with my 2000 CRV, 2.0 L 50,000 miles. The radiator cooling fans will not come on. The fuses are good and the...
David, It sounds like every thing in your heating and cooling system is operational and about right where it should be withe exception of "Perhaps" an unknown...
I took my '98 CR-V with 226,000 miles in last week for a timing belt water pump service and when I got it back it now has a lot of lifter noise that it didn't...
Jeff, Here is what I suspect and it is up to Honda to check it out since they performed the work. While they were replacing the timing belt and the water pump...
Just about to get under my 09 CR-V to change my oil for the first time. What is the oil drain bolt size? Also what size oil filter wrench should I use? ...
Mine is an 04 and the bolt takes a 17mm wrench. The oil filter is pretty small...don't know the OD. I use one of the small adjustable size. Also be sure your...
If you get codes P-1176 and P-1177, you will need the primary (front) O2 sensor replaced. This feeds back information from the catalytic converter to the...
Kathleen, I suspect bu "DRAIN BOLT SIZE" you mean the wrench size?? If so it is 17 mm. You remove the oil filter with either a fixed sized socket cup wrench ...
The check engine light on my '02 CR-V (161k miles) has been on for a couple of weeks. Brought it into the dealer today and they said that it has a bad throttle...
Not sure what a bad throttle body would do (probably not help anything), but a bad PRIMARY (front) O2 sensor will hurt performance and mileage, because it...
I just had one of these primary 02's go out on my 04 EX with 88k miles. I lost about 2-3 mpg. Luckily I had the Ex Warranty for 100k miles so it was replaced...
Susan, Depending on brand and your exact replacement part # the O2 sensor part is priced between $140 and $180 at Checker Auto and I feel sure you will do even...
Thanks to everyone who replied. When I heard the repair cost, I was bit overwhelmed, but the responses on this board made me calm down a bit. A co-worker...
My Honda dealer finally fixed the problem. Thy told me the timing on the rear cam was off by one tooth (whatever that means) and they had to do some kind of...
Jeffrey said: "They loaned me an '08 CR-V to drive while the were working on mine and I must admit it made me think of trading for the first time in a long...
Just wanted to give everyone an update. Got my CR-V back from the mechanic today. It took them 4 days, but they finally figured out what was wrong and were...
They charged me $800 which seems like a lot to me, but definitely not as high as the $1350 the dealer quoted me for the bad throttle body/02 sensor that turns...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
