Hello All, Since one of the properties of ethanol is the cleaning of carburetors and injectors by disolving gum and varnish in automobiles I was wondering, if...
You can get a Plexi 3 shield from motorcycle accessory warehouse for $115.95. I bought mine from there a month ago, they have good prices. As for the shield,...
The (~$40) ATV/motorcycle jack doens't work well because of the pipes and stuff, there is not a flat surface on the bottom of the bike. BUT, there is an...
here is the adapter http://www.motorcyclejacks.com/adapter.shtml but you are right it`s very expensive $70. Do you think that two blocks of wood would do a...
Would someone be able to take a picture of the inside of the turn signal switch from an 82 Nighthawk? I had it apart to fix some soldered connections, and now...
Reid - Is it possible for fork bushings to go bad in 4000 milies? Like I said, I replaced them not too long ago, and would hate to have to do it every season....
Group - Well, most of us put our bikes up for the winter due to bad driving conditions. So, to keep things hopping on the board, and to keep the creative...
My winter project is to ride as much as possible. Living in Georgia means that there aren't that many days that you can't ride, as long as you have the proper...
Check this out - description of putting a Plexi III on a NH 750: http://www.nighthawk750.com/mods/plexi3.html Nice looking windshield, and better adjusters...
I've said that the three greatest inventions of the 20th century were Polarfleece, Gore-tex and the Internet. Now I'm not so sure about the Internet. :-) ...
Hi there bill i would sell you my extra 1982 650 night hawk handle bars they have all the controls on them and not taken apart...I parted out one and have...
Hi Josh, aaarrrggghhh!!! ... I don't want to think about winter projects! But since you asked: I'd like to provide a little heat for the garage so I can...
... Actually, table lifts are _great_ for taking wheels off. They generally have a hole in the rear end for dropping the wheel out easily. The wheel you aren't...
Lucky you, Scott. Back in '73 I spent a summer in Oklahoma, courtesy of the US Army. While there I raced sailboats with the local club and learned that the...
Andrew, you have to use tie-downs for safety on _any_ lift, including table lifts. A properly tied town bike which was originally lifted at it's center of...
Eh. If you're going to specifically pour something in to clean your carbs, use one of the dump-in carb cleaners, like chevron techron. They're a combination of...
Hi Andrew, Thanks for the link! I have one of those ATV/motorcycle jacks that I got for $40 from Kragen. I used it for my Bandit. I had to be very creative...
my plans: I want to replace my brake lines as well. Also replace all my control cables that havent been already. an now for the strange stuff: I want to get...
No, bushings can last tens of thousands of miles. Maybe the shop misassembled the forks. Perhaps the bottom piston bolt is loose, or maybe they left out a...
howdy all I just picked up a '93 750 Nighthawk from a friend who doesn't have the owner's manual. what is the proper way to check the oil? on the side stand?...
Not sure about checking the oil on a 93.....since I don't think those have a centerstand (?) . Our older Nighthawks are checked on the centerstand (level) ,...
John From the owner's manual for a 93 CB750 Nighthawk - ENGINE OIL LEVEL CHECK ... 1. Start the engine and let it idle for a few minutes. Make sure the red...
How long did it take you to install it Tom? Paul... ... for $115.95. I bought ... shield, the plexi 3 does a ... over the top of the shield, ... the wind off...
... It took about an hour, but I had to remove my summer shield as well (Targa Tsunami). I guess it took about 30-40 minutes to put on the new shield. The nice...
It was only 37 degrees the other night in Maryland, and I began my ride home from work at about 8pm. Feeling that it was above 32 I proceeded onto the road...
greg, so glad you & the bike are fine~ …hey, you must have pretty good reflexes, not to mention good luck to have no cars “standing on first” to tag you...
Hi Jen, when I had springs installed on my 82' 450SC rebuilt clutch I only had them replace half w/hd and the other half w/stock.The mechanic said that...
I have the P3 and using it in winter helps me to wear less insulative clothing to keep warm.It's as big as a barn door but you'll thank yourself for getting...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
