(1) the atmosphere is friendly and relaxed. We do not welcome abusive language or profanity. We are also thankfully short on flame wars, so let's keep it...
gt4@yahoogroups.com
May 2, 2005 1:13 am
101139
Technically the tranny CAN be used in 2WD with the selected switched, however its only advised to be used for towing or dyno work, not general use. I don't...
... FWD??? i think ill fit ok on my car.. thanx a lot Hi there, It's much easier if you use the MR2 tranny instead. It's a RWD box, but can be modified to FWD....
The MR2 turbo box will fit straight on and is a FWD box basically, they are almost the same as a Celica's GT box but with stronger gears and different ...
Hello all, I am a new owner of a ST185 Celica GT-FOUR JDM import and I have had some problems with my factory ECU. I was driving along and the engine just...
Plenty of JDM ECUs around mate. Don't pay more than $100 for it. Check www.toymods.org.au in the Electronics Classified, there are usually a few in there. ...
OK, point taken about ST185 prices. Mine is available to UK buyers at £2000 cash, no offers. few dents on rear offside, new transmission parts & wheel ...
Hi everybody: I need some help because I've an oil shift system pipe broken, and as Toyota Spain follow their internal procedure requesting the item to...
Hi Gert the part is a couple of pipes that goes down the engine almost in the front of the car behind the water radiator as the spanish proverv says "One image...
or toyotaworld.com. 800-327-2087 Guy named jeff can get any parts (even non U.S. Toyota parts). With a credit card they will sell it to you at a discount...
Jon Prine
supra@...
May 4, 2005 5:30 pm
101151
I posted a couple months ago about my 91 US Spec all-trac would not stay running. It will run as long as you hold the switch in the starter position, but as...
Hi, wondered if anyone out there has any knowledge of MOT's and what I can do about a little problem I have come across. Basically i took my GT4 to be MOT...
White 1990, 151,500 miles, under 20,000 on tranny and clutch, beside needing a new windshield it is clean and straight, located near Seattle WA, e-mail...
... Sorry for the late reply, I just got back from a trip. I think it was the original box and diff, so it was at that time, probably about 8 or 9 years old??...
Useful Info: Check out the new FAQ at: http://www.rennison.info/newgt4faq/index.php Unsubscribe: gt4-unsubscribe@egroups.com...
gt4@yahoogroups.com
May 8, 2005 2:32 pm
101156
Mark, Check out this thread: http://alltrac.net/phpBB2/viewtopic.php?t=5305&highlight= On Thu, 05 May 2005 18:15:21 -0600, Mark Saville <headsmail03@...>...
Ok i'm geting a new turbo I've searched around and checked a ton of compressor maps and done a lot of math and really cant figure out what is going to be best....
i have been going through this process at the moment as well. i have not been able to find turbine maps for the t3 or t4 series turbos. i have only been able...
Hello List, Just a simple question. How many centigrade or F of the engine temperature range on ST185 when the gauge reading on the middle, and on 3/4? Assume...
It varies from car to car, none of the gauges or senders are consistant enough to give a gauge poestion a tempature refference... whatever the normal poesition...
With the stock thermostat (82°C) the needle is mostly sitting exact in the middle, even if engine temps are rising to100°. I have seen temps of 98°, with...
Bloem
flower@...
May 17, 2005 5:59 am
101164
Thanks for the info Roger, Yes some real turbine maps would be awasome and also some way of relating that info back to how they would perform with a given...
... Where did you get this information? I've been looking for it for a while. -- Josh 92 ST185 Colorado, USA "Put all your eggs in one basket and watch that...
Josh, I just measured out the ct26 and did the math comp trim = (inducer diameter squared / exducer diamater squared )* 100 turbine trim = (exducer diameter...