Dear Fellow Geely Members, Thank you for your assistance with obtaining material which I could work with on my JLQT50-16. Just getting together enough...
Hi guys, I have a scooter out there that is a 4 stroke 50cc Hitong that we have had trouble getting to run correctly. Here are the symptoms: You give it gas,...
soiunds like a dirty carb or incorrect adjustments to me take teh carb apart and clean it out and also blow out the jets , also if it's teh original fuel...
also check that the alecelator pump on the carb is working correctly and that the jets are not too big it very well could be that the carb bowl is emptying...
new or old? could be a lot of things but check the vaccum line and the petcock. Could also be a kinked fuel line. If it happens after a while, it could also...
I agree with Pauls first post, dirty jets. I don't think it's the accelerator pump though. If it was it would hesitate intially but then work fine. ... have ...
well tomas if your like me and dont' work the throttle a lot the ccarb bowl will empty out and the pump woudlnt' be filling it up as much that is why I ...
I have created two scooter-related surveys. These are mainly targeted to help people decide what type of scooter and what dealer would work best for their...
Thanks for all the feedback guys. We will see what hapens. In geelyscooters@yahoogroups.com, timmy clements <jetstar231979@...> ... and dont' work the throttle...
I have only had it for a few weeks (brought second hand) and had a few problems, a week ago it would not start, so i took off the carb cleaned it and got it...
o.k. you have a new coil and cdi no spark try putting in a new plug and see if that helps and check to see if the wire is in the coil and plug boot is in...
also change the feul and vacume lines and fuel filter fill the tank up with fresh clean gas and the line that was hooked up to the front of the carb on the...
check all the plugs in the wiring harnesses to see if one came loose. The one by the right side of the engine comes from the magneto. There are also one or...
Check out the stater coils for resistance values, especially the small pick-up ignition trigger coil that sits very close to the flywheel. Also, get a volt-ohm...
I have a minor problem regarding a drip from the bottom of the carburetor. The carburetor is on the JL50QT-16 Scooter. I have attached a picture of the...
yes that is a drain there should be a small screw near there to let you shut it off and a rubber tube on the botton of that nipple Paul ... From: "Lew...
Thanks Paul, Wouldn't you know it, some things are always out of sight and where you can't get to them. It looks like I may have to struggle and pull the...
Paul, I was able to remove the carburetor fairly simple. Off with the air filter box. The carb is attached to a special rubber type manifold hose and held in...
yes that is the screw I was talking about, while you had it off you should ahve taken the bowl off and taken each jet out and blew it out with compressed air...
As for the carburetor, I did not want to open it up since the scooter it's running great. This Model 16 is a screamer. This scooter has the Minarelli based...
It's a 90.3cc engine. It will do 47mph flat out, 52 on a slight down grade. ... scooter it's running great. This Model 16 is a screamer. This scooter has the...
Hey Tom, This scooter belongs to my neighbor and I did away with the oil injection system for him. He lives in St Louis, and brought the scooter here to his...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
