This is a pretty late response, but make sure you have the proper XDF file loaded (found in files>1g>Tuner Pro on this board), and that the offset is set...
It's hard to say for sure since different mods will flow different ammounts of air. A stock DSM will be at higher boost with lower load while a modded car...
I'm just starting out with this. Basically just reading up on all the info I can find and trying to make heads and tails of it. It appears my ecu# is...
I'm just starting out with this. Basically just reading up on all the info I can find and trying to make heads and tails of it. It appears my ecu# is...
Hi I would like to know if it's possible to be able to log the MAP row position in case I'm not using the extended maps mod. Will it work if I replace the two...
How hard would be to connect the wideband output to the egr temp input on the ecu and be able to log AFR correctly? My PLX M-300 has a wideband output of 0-5v...
You'll need a chip burner, such as the Moates.net burn1. This lets you plug the chip into your computer and read/write/ and edit the chip. Or you could visit...
No buffer needed w/ 0-5v output. Lots of people have done this (run a search on dsmtuners). The trick is getting a logger that converts the voltage to AFR so...
I can't see any picture. I've suscribed to receive the digest once a day and the attachments aren't included. If You could send it again to my adress it would...
i own a 4g63t with wiseco pistons 8.5 comp,act racing clucth,LSD transmission,609 air flow, 550cc injector, tdo5h turbo and it ran only 15.3 in quater mile.....
There must be someone that works on electronics. I wouldn't recommend doing it yourself unless you do A LOT of practice first on other stuff (like shot...
I am looking for source file of MMCd 1.8g - version published on 3Si by cbatter's. Witch version is made by jconroy's ? As I wrote before, i am trying to...
... Clint Battersby never released the source to 1.8g. If you can convince him to do so that would be great but I never had any luck doing so. The last source...
I received a .bin and .xdf from a person on dsmtuners with a setup similar to mine. My setup is basically stock with the free mods and most of the stage 1...
I was planning on running 950cc injectors and recieved a base bin to start with from a forum member. I decided to go with 880cc injectors instead. What do i...
... If you are using tunerpro, adjust the injector size, also make sure your deadtimes are correct for the injector/brand you are using. Make sure your 2g mas...
I usually burn 512 chips, so with a 256 i set the offset in the burner to c000h. It seems to work, but i don't have a car to put it in to check. Is that how to...
What base fuel pressure are you running? The other thing you need to know is that many injector vendors lie about their sizes. The Delphi injectors that some...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
